Distributors and Distributor Caps
Chevy Blazer S-10
Honda Civic DX

How do you change a distributor cap?

727374

Top Answer
User Avatar
Wiki User
2015-07-15 21:45:09
2015-07-15 21:45:09

what type of vehicle is it? paul

its a 93 s10 im hookin up a tach and i need to kno witch wire it goes to it said the negative side but im not sure witch wire it is

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

There is no "chip" that can be replaced in the distributor, it is serviced as a unit. There is no chip in the distributor cap.

User Avatar

To change the distributor rotor on a1998 Honda Civic unplug the spark plug wires from the cap. Loosen the screws and remove the cap on the unit. Be sure to properly line the new cap on the distributor and install.

User Avatar

A 1993 Intrepid does not have a distributor cap.A 1993 Intrepid does not have a distributor cap.

User Avatar

It does not have a DISTRIBUTOR OR CAP

User Avatar

It does not have a distributor cap.

User Avatar

Points, no. Distributor cap, yes.Points, no. Distributor cap, yes.

User Avatar

buy a new distributor cap and rotor. Unscrew the distributor cap (on the drivers side of the engine block), take note how the existing rotor is sitting, remove it, and place the new rotor in the same position. Put on the distributor cap and screw it into place... very simple job. thats how you change the rotor......he asked about the distributor....try again.

User Avatar

buy your parts,usually change plugs to.make marks on your distributor or usually they are marked with dent.replace distirbutor cap and replace the cabels .with numbers.

User Avatar

there is no distributor cap nor distributor

User Avatar

there ain't one eof those u have coil packs and no distributor

User Avatar

remove the distributor cap and grab the rotor then pull straight up.

User Avatar

I don't think the 97 has a distriburetor.

User Avatar

it does not have a distributor cap, it has a coil pack, all you can change is the plugs and wires, just fallow the wires from the plugs back to where they end and theres your coil pack, butch

User Avatar

The distributor cap is located where the spark plugs cables are connected .They go from the motor to the distributor cap.

User Avatar

There is no distributor cap, only a ciol pack that the plug wires go to

User Avatar

There is no Distributor cap or rotor in a 91 Mazda Miata. All years of the Miata use electronic computer controlled ignition systems.

User Avatar

change your distributor cap and put new wires as well as the rotor drive safe change your distributor cap and put new wires as well as the rotor drive safe change your distributor cap and put new wires as well as the rotor drive safe

User Avatar

The distributor cap is replaced just like any other GM cap. You need to remove the "doghouse" between the front seats and below the cup holder/radio-CD counsel.

User Avatar

you do not adjust a distributor cap you adjust the timing.

User Avatar

yes. +++ In fact it's how the timing is adjusted.

User Avatar

Unscrew the screws holding the cap and lift it up and away from the distributor. Pull the rotor straight up and install the new one.

User Avatar

Unplug the wires going into the distributor cap, be sure you know which wire goes to which terminal or your car will not start if they are wrong. Remove the 3 bolts that hold the plastic cap to the metal distributor. Put the new cap back on, replace the bolts, and plug the wires into the appropriate terminal.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.