Distributor cap should have 2 clips - release these
Rotor should just pull off - has a key to install in proper position make sure new is installed with key in slot Replace distributor cap -(should have a pin to insure it goes in only one position) Move one wire at a time from old to new so they don't get mixed up
need to change all the plugs, change cap and rotor, change air filter, also probably change distributor wires
You can't. They have a distributor pack, and not a cap and rotor. a 1.6 eng 93 geo storm has a distributor cap and rotor!!!
It could be a cracked Rotor Cap, or bad ignition wires
Bad coil? Bad distributor rotor? Bad distributor cap?
In the distributor,you need to remove the dist cap & then remove the rotor and it will be mounted to the distributor housing
Do you mean rotor? If so, remove the distributor cap and remove the old rotor and install the new one. Simple repair.
1 - 5 - 3 - 6 - 2 - 4 The distributor rotor turns CLOCKWISE
Change it. Don't be a dumb.
start with checking the fuses, coil wire, distributor cap and rotor.
make certain your rotor is turning as you try starting it.If you remove the distributor cap and watch your while someone turns the engine over your rotor should turn, if not, you might have a sheard pin on the distributor gear or a broken timing chain or belt.
1993 Ford Thunderbird tires are generally 15 inches.
A 1993 Intrepid does not have a distributor cap.A 1993 Intrepid does not have a distributor cap.