• Serpentine Belts
  • Chevy Caprice Classic
  • Timing Belts and Chains
  • Scooters and Mini-Bikes

How do you change a drive belt on a 90 Caprice?

Top Answer
User Avatar
Wiki User
Answered 2015-07-15 21:10:57

it should have a belt tensioner, use a 3/8 or 1/2 ratchet in the square hole and push to the left or right and pull the old belt off, hold the tensioner after you got belt set to go in place, slide that part of belt under tensioner and let go, alot easier than dealing with v-belts.

User Avatar

Your Answer


Still have questions?

Related Questions

Craftsman 917.275350 belt length?

The deck belt is 90 1/4" The drive belt is 95"

Can Rims from 90 caprice fit 87 caprice?


How much does it cost to change a timing belt and a serpentine belt on a VW Beetle?

$90 bones

Will rims from a 90 Chevy Caprice fit on a 89 Chevy Caprice classic?


What interior will fit a 86 caprice?

1977-85 Impala, 1977-90 Caprice

What year caprice steering column will fit a 1989 caprice?

Any 1977-85 Impala or 1977-90 Caprice will work

How Fast Does A Chevy Caprice Classic Go?

I have a 90' Caprice with a 305 that I brought up to 130mph.

How do you change a serpentine belt on a 1990 Cadillac Sedan Deville?

changing serpentine belt and pulley 90' sedan deville

When should you change the timing belt on a 1992 Honda Civic?

I have a '90, my timing belt went at 90,000 miles. the guy at the garage said you should change it at 65,000-70,000

90 topaz alternator pulley starts smoking but is still charging the battery?

the belt is worn and loose change the belt and tension properly

How do you know if or when should change timing belt on 90 prelude?

the timing belt needs to be replaced every 100,000 KM. I would change it a little prior to that. If it breaks, you can bend your valves.

Will a serpentine belt change on a 90 Pontiac grand prix require removing engine mounts?

Absoultly not.

Will a 350 5.7 from a 91 caprice fit in a 90 camaro?


Length of drive belt for cub cadet 1315 the deck has only 3 pulleys and says 1320 on it. I need to know the length of the belt?

Should be 90 inch same as the 1315

What is the engine oil capacity for 305 ci 1990 Caprice Classic?

well my 86 caprice is a 305 also and its a 5 quart capacity. so I'm goin out on a limb an guessing the 90 caprice is also a 5 quart capacity also. well my 86 caprice is a 305 also and its a 5 quart capacity. so I'm goin out on a limb an guessing the 90 caprice is also a 5 quart capacity also.

What is the wheel base of a 90's Chevrolet caprice classic?


How do you change a AC belt on 90 Acura?

You need to loosen the belt tensioner. There is a large bolt that needs to be loosened in the center of the tensioner pulley. Then the small vertical bolt is turned in the direction to loosen the belt. After the tensioner is loose replace the belt and retension it.

How do you replace a serpentine belt on a 2002 chevy tahoe?

locate the belt tensioner (left side if facing motor). using a 3/8 drive ratchet turn the tensioner 90 deg counter clockwise. remove old belt. rerun new belt according to diagram and reinsert ratchet turning 90 deg again counter clockwise. place slack in belt over tensioner and release the ratchet.

Will rims off 06 charger fit 90 Chevy caprice?

Not without modification

When to change Toyota sienna 2000 timing belt?

I think it is 90 000., but check your owners manual or call the dealer to be sure

Does a 2002 Camry V6 have timing chain?

This is a question that's asked a lot. The V6 has a cam drive 'belt' rather than a chain. The belt is scheduled for a maintenance replacement every 90 thousand miles. Cheers

What can Bevel gears be used in?

Bevel gears can be used to change the direction of drive in a gear system by 90 degrees

Where is the Oxygen Sensor on a 90 Caprice V6 43L?

There is one before and one after the catalytic converter.

Where is a fuel pump located on a Chevy Caprice 1995?

in the fuel tank, its like $90 at carquest

How many miles do you drive before changing your timing belt on a 2003 Isuzu axiom?

80k The above answer is incorrect. The belt requires changing at 100,000 miles under normal conditions. If you drive in severe conditions, then change it at 75,000 miles. Warning: This engine is an Interferance Engine and as such if the belt breaks serious engine damage will occur. Also the water pump is driven by the same belt. To save on future labor costs, replace the water pump at the same time you replace the belt. Considering the average driver is in severe conditions 90% of the time, I wouldn't say incorrect. Just a safe median.