answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change a flywheel in a 88 bronco 2?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Want to Change oil pan gasket on 88 bronco 2?

no.its pritty tough


How can you bleed the hydraulic clutch on my 88 bronco 2?

Dumdassesssssssssssss!


How big is a new flywheel on a 1988 Bronco 2 29L engine 5 speed transmission 4x4?

The automatic flywheel is : Teeth = 138, Outside Diameter = 11.69"


1989 ford bronco 2 2.9L When you go to start it the starter doesn't engage the flywheel and you end up pushing it to start you've replaced the start two times and still the same problem?

you are probally missing teeth on the flywheel you should replace the flywheel.


Can you put automatic transmission fluid in a manual transmission of a 88 bronco 2?

No. They require entirely different products


How much horse power does a 88 ford bronco 2 XL have?

I BELIEVE the 2.9 liter V6 engine in a 1988 Ford Bronco II is rated at ( 140 horsepower from the factory )


You need a hose diagram on a 88 bronco 2 29?

try autozone.com they have a very helpful section in their repair info pages.


Door chime on 88 Ford Bronco II is on all the time how to get to it to unplug it?

now I'm not quite sure about bronco II's but in my 93 bronco the box was located under the driver side of the dash more towards the middle. The box is about 2 x 2 1/2 inches, and has a 7 prong connector I hope this helps


88 ford bronco 2 runs rough ildling up and down?

Remove, clean, replace IAC (Idle Air Control).


My 88 bronco 2's rpm jump up down like it is the alternator or battery has a dead cell which is it?

idle air controler


How do you change brakes on 1989 bronco 2?

go to midas or meineke it will be as cheap and much cleaner.


What would cause an 88 bronco 2 v-6 to idle hgiher than normal idle screw not even touching?

timing is advanced to far