take it off and put the new bumper on replacing all screws nuts and bolts from the first bumper
you take it off and then you put the new one on!
Unbolt the front of the wheel well liner inside the wheel opening.Remove the bumper cover bolt from the bracket located inside of the bumper at the end.AT the front of the car, remove the bolts holding the bumper cover on, located underneath the vehicle.You should now be able to remove the bumper cover from the front of your Dodge Intrepid.An instructional video has been included to show you the removal process.
Not sure *which* light cover is being asked about, but the "Related Questions" below will cover all 3: headlight, taillight & running light in the front bumper cover
how do i change the front bumper on my 1999 vauxhall vetra
Park the Impala on a level surface and engage the parking brake. Remove the keys from the vehicle's ignition.Crawl underneath the front of the vehicle and use a slotted screwdriver to pry off the splash shield in each wheel well directly in front of both front tires. Once the shields are removed, you can access the screws securing the bumper cover to the fender.Remove the two screws on each side of the bumper cover with a Phillips screwdriver.Remove the bumper cover from the front of the vehicle by pulling it up and off the Impala. You may need another person to help you remove the bumper cover. Install a new bumper cover by placing it onto the front of the Impala.Crawl underneath the Impala again and reinstall the two screws on each side of the bumper cover. Reattach the splash shields to the wheel wells.
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
You must remove the front bumper cover.. There is no way to get around it, unless you drill holes in the cover where the light mounting screws are located..
Between the headlights there are two screws and a plastic clip that needs to be removed.On both ends of the bumper cover there are two 10MM bolts that need to be removed. On is inside the wheel well under the wheel well liner, and the other is on the bottom side of the bumper cover near the wheel well.In the front of the car there are 2-3 more plastic clips that hold the front bumper on that need to be removed.I have also included an instructional video below that will show you the procedure for doing this.Hope this helps,1ATony
Behind the front bumper cover
To replace the front bumper cover and the front reinforcement(along with painting and installing it) a dealer will charge you about $850
# Apply parking brake,raise the vehicle and secure it # working under the vehicle,detach the fasteners securing the lower edges of the bumper cover # Working in the front wheel opening,detach the retaining screws securring the bumper cover to the inner fenderwell splash shield # Pry out the lower edge of the splash shield,then reach up behind the bumper cover and remove the bumper cover fender retaining nuts # remove the fasteners securing the upper portion of the bumper cover and pull the bumper cover assembly out and away from the vehicle. # Disconnect any electrical connections which would interfere with removal
Depends on year of vehicle from 2006 up involves front bumper cover removal you can also find video on you tube