answersLogoWhite

0


Best Answer
Copy

you must drop the fuel tank. the fuel pump is inside the fuel tank.unhook battery first as we dont want any sparks while working near gas and electrical connections. then remove mouting bolts to un secure the gas tank from frame this will allow you room to disconnect fuel lines. then remove tank and then fuel housing. to remove fuel housing you will need to bend metal tabs. then rotate fuel housing counter clockwise to remove at this point you will see fuel pump and float assembly. access granted.

User Avatar

Wiki User

โˆ™ 2006-09-14 03:56:25
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you change a fuel pump in a 1993 Chevy S10 Blazer with a 4.3 engine?
Write your answer...
Submit

Related Questions

How do you change an ignition module in a 1993 Chevy blazer?

your a fatty


Where is the horn located on a 1991 Chevy Blazer?

Where is the horn located on a 1993 chevy blazer


Where are the sparks plugs located on a 1993 Chevy blazer?

if you have to ask this question, then you shouldn't attempt to change them...


Locate the water pump on a 1993 Chevy blazer?

It is the part that the fan bolts to, on the front of the engine GOOD LUCK


What is ignition timing for 1993 Chevy blazer with 4.3 engine?

1-6-5-4-3-2


How much does a 1993 Chevy Blazer weigh?

3500


How do you set the timing on a 1993 full size Chevrolet blazer four wheel drive with 350 engine?

how do you set the timing on a 1993 Chevy pick up


How do you change auto transmission fluid in 1993 Chevy blazer?

You will have to remove the transmission pan that is on the bottom of the transmission to drain the fluid.


Will a engine out of a 1991 blazer fit into a 1993 Chevy f150?

if it's an f-150 it a ford not a chevy so no a chevy motor will not fit in a ford without changing the entire drivetrain and computer .


Are 1993 Chevy Tahoe doors interchangeable with 1987 Chevy Blazer doors?

yes they are


Are most parts on a 1993 GMC Jimmy compatible with a 1993 Chevy Blazer?

yes it is


What is the firing order for 1993 Chevy s10 blazer with 4.3 vortec v6 engine?

1, 6, 5, 4, 3, 2.


Does a 1993 Chevy S10 Blazer have a Inertia switch If so where is it?

None


What would make my dashboard lights not work in my 1993 Chevy blazer Tahoe?

A blown fuse can make your dashboard lights to not work in your 1993 Chevy Blazer Tahoe. A burned out bulb can also cause this.


Will a trans from a 1978 305 engine Chevy van work on a 1993 Chevy pickup 4.3 engine both automatics?

Yes but you might have to change the driveshaft


What is the towing capacity for 1993 4x4 Chevy Blazer 350 Silverado 1500?

if its a full size blazer 7000lbs


How much engine oil does a 1993 Chevy k1500 v6 take to change?

5 quarts


Were do you ground the temperature sensor for a 93 s10 blazer 4.3 vortech?

The 1993 Chevy S 10 Blazer 4.3 liter engine temperature sensor can be grounded to the engine block. You can use the temperature sensor retaining bolts to ground the temperature sensor.


Where is the oil pressure sensor on a 1993 S-10 Chevy blazer?

4.3 L? Top rear of engine, just to the drivers side of the distributor.


Where is the fuel pump fuse located on a 93 S10 Blazer?

which fuse is for the fuel pump in a 1993 chevy s10 blazer


What size is the dash speaker of a 1993 Chevy blazer?

4x6 in the front dash


What does the abbreviations CTSY stand for in the fuse box of a 1993 Chevy blazer?

courtesy


What is the order for replacing the spark plugs on a 1993 Chevy Blazer with a 4.2 liter Vortex engine?

You can replace them in any order. Just do not forget which plug wire goes to which cylinder.. The engine is a 4.3


How do you change spark plugs on a 1993 Chevy Lumina?

Spark Plugs on a LuminaSee the related questions to the right. HOW DO YOU CHANGE THE SPARKS PLUGS ON A 1993 CHEVY LUMINA APV 3.8L 231-V6 ENGINE (an van)


Why does your 1993 Chevy blazer struggle going uphill?

Fuel filter may be plugged. Catalytic converter may be plugged. Engine may be in need of a tune up.