To change a tail light bulb on a 1998 grand prix you have to first take out the carpet from the trunk. Next, you will be able to get to the bulb just remove the case holding covering the bulb then twist, remove and switch the bulb.
To change the brake light bulb on a 1999 Honda Passport find the light housing located in the trunk. Find the plastic covers for the lights and remove them. Pull the bulbs out carefully and replace them.
To change the front signal light bulb on the 1999 Honda CRV, pry up the fender fastener to expose the bulb socket. Twist the bulb socket 90 degrees and remove from the assembly. Turn the burnt bulb counterclockwise and pull out. Replace with new bulb.
If its the rear, open the rear hatch. Look on the side of the taillight, you will see 2 screws. remove them and pull the tail light out, and you will see 3 grey sockets. Untwist it about 1/4 turn and pull it out. The bulb can then be pulled out, and it should be a 3157 bulb.
The license plate light bulb in a 2003 Suzuki Grand Vitara can be accessed and changed through the rear cargo area. A portion of the rear door panel will have to be removed. There is a small rectangle that can be popped out by using a screwdriver that is in the middle bottom of the door.
There are two screws on the top underside that you must take out. then the bulb is attached to a wire and you can pull it down about an inch to help pull out the bulb. put in the new bulb and screw the screws back in and youre all set. -richard
The tail light bulb on a 1999 Chevy Suburban is replaced by removing the retaining screws, pulling the bulb assembly away from the vehicle, and unscrewing the bulb. A new bulb can then be installed and the assembly screwed back in place.