To change the Low Beam headlight bulb on a 2004 Chevrolet Epica you need to:
1) Remove the 3 bolts (Metric size 10) holding the headlight assembly in place. There are 2 at the top and one on side beside the grill.
2) Gently start to slide the whole assembly out, while lifting slightly to get over the bumper.
3) Unplug the signal light to allow you to get additional length. (There is a little pressure connection you push in to allow you to unplug the signal light).
4)Without the signal light wire attached you can swing the whole unit out towards the grill and rest on the bumper.
5) Slide the two retainer clips holding the back cover of the headlights to their respective sides.
6) Removing the cover will expose the high/low beam light bulb. It is held in place by a wire and secured by two Phillips screws. Loosen the screw closer to the grill. Be-careful as it is under a bit of pressure.
7) Once loose enough you can pry the wire out and the bulb is freed.
8) Put in new bulb, be careful not to touch the glass part of the bulb.
9) Secure the wire again, and tighten the Phillips screw.
10) Replace the cover and slide the two clips into place
11) Check the high beam connection to ensure it has not disconnected or come loose.
12 Slide the assembly back towards proper place so you can hook up the signal light.
13) Slide into place, there are two plastic pegs that need to slide into their respective holes as you slide the assembly back into place.
14) Put in the three bolts and tighten.
15) Test the lights to ensure everything is working.
Presto, you've likely spent approximately 10-15 minutes and saved yourself $30-$50 and a ton of time at the garage or dealership.
There's no such thing as a Chevy Epica...
hammer
My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb? My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb?
== == That is how you change the actual headlight but the question is how to change a fuse.
The drl module on chevy epica 2004 is back to the data link connector
How do you change a headlight bulb on 1 2004 Hyundai XG 350?
* *
How do you Change Windshield Wiper Blades on a 2004 Chevrolet Trail Blazer?
there is two of them one is infont of radiator on frame
Nicole
Look in the manual.
Begin by removing the wiring harness from the back of 2004 Volvo headlight. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.