Hello, this is straigh from the Dodge repair manual. If you need pictures let me know John
Roll window down.
Remove window crank, if equipped.
Remove screw attaching trim panel to outside mirror frame.
Remove screws attaching pull cup to door.
Using a trim panel removal tool, disengage clips around perimeter of trim panel, attaching trim panel to door.
While holding bottom of trim panel away from door, simultaneously lift upward and inboard.
Disengage power mirror switch connector, if equipped.
Disengage power window/lock switch connectors from switch panel, if equipped.
Separate trim panel from door.
Remove door trim panel .
Peel waterdam away from adhesive around perimeter of inner door panel
Remove the door waterdam .
Remove nuts attaching door glass to window regulator.
Remove glass from door or move glass to full up position and secure glass to door with tape.
Disengage power window motor wire connector from door harness, if equipped.
Remove bolts attaching window regulator to inner door panel.
Separate window regulator from door panel.
Extract window regulator through access hole in inner door panel.
To remove the window regulator in your 2005 Dodge Stratus, you would need to remove the door panel, and then the water shield behind the door panel. Tape the window into the up position with tape, and then you can access all of the nuts and bolts to remove the window regulator. I have included a link below to an instuctional video that will show you how to do this on a 01-06 Dodge Stratus.
remove the clip retaining crank to the regulator shaft, this requires a special tool available at most parts houses.
You will need a new regulator assembly.
replace window regulator assembly.
Bad window regulator. The cables are not pulling evenly and it tilts the window.
First you need to remove the door panel.Then remove the door handle bracket.Peel back the moisture shield.Tape the window into place,then unbolt the window from the regulator.Remove the window regulator from the access hole in the door.
first take of the door panel. Next you will see the window regulator. The there is going to be 4 bolts or so that you are going to need to take off, after that unhook the window. Then pull the whole window regulator out and replace the whole thing
either the junkyard or see if a parts store can get it for you.
on the 01, probably close enough to the same thing, remove the door panel, then you need the window about halfway down, there are two bolts that hold the window onto the regulator and two bolts on the bottom and two on the top of the regulator. it helps if someone can help hold the window, if not duct tape works pretty good.
Most likely the guide on the bottom of the regulator broke. take the door apart and check. most likely, you need a new window regulator.
check your owners manual.
remove the door panel, window regulator, and window track. lock solenoid should now be accessable You will have to replace the latch, the solenoid is part of the door latch.