1. Jack it up and axle stand it (better with drive on ramps)
2. remove the very front dirt shield (black plastic, about 8 torx head screws, two in front of each wheel and several across the front of the car
3. remove the two 10mm nuts that hold the fan on (one on each side) best doing from the top
4.remove the water pipes
5. undo the radiator support pieces (two metal plates underneath held by 2 8mm nuts each)
6. carfully lower the rad down and undo the two 8mm bolts that hold the air con radiator onto the main radiator bolts are in each bottom corner (this also has two metal tabs half way up that slide into plastic supports on the main radiator, jiggle it gently and pull it down should split them).
7. install your new rad in the revers order!
It is the fan blower for the engine cooling system (Radiator)
The first step in changing a Ford Mondeo radiator is to loosen the clip holding the bottom hose in place and drain the system. Then loosen all other hoses and remove the radiator mounting bolts. Then perform the above in reverse, filling the system with the proper coolant.
Where is the Dash board lights fuse of ford mondeo 2002 lx
where do you fill radiator on 2001 ford taurus
There should be
how to replace radiator in 2001 ford escape 3.0 engine
how adjast timing chain for mondeo 2005
how do I remove the alternator off a 2001 mondeo. There seems to be a bolt stopping it?Type your answer here...
The 2001 Windstar has no radiator cap. It has an antifreeze bottle.
To change the coolant in an AU Ford Falcon 2001 model, open the radiator drain plug and add warm tap water once all coolant stops coming out. Again drain the radiator and add the coolant.
inlet manifold about halfway down
60 litres