Hire a professional technician!
Hire a professional technician!
From BLUESTG: All the door lock actuators are the same. They are labeled front, back, left, and right for the bracket that is put on them to attach it to the door. So you can buy any door actuator and just reuse the bracket in you current door. Just remove the rear door panel, it is held in place by plastic push in pins. So you may have to pry it a little to get it off. Reach up a pull out the connecting rod from actuator to the lock. Drill out the two rivits. Lower acturator and disconnect the wiring. Transfer bracket to new actuator. Connect wiring. install with new rivits, but I recomend short screws. The rivits tend to elongate after a lot of actuations. Attach rod from the lock. Test, and push on the door cover.
change low beam lite in 1999 suburban
Yes you can.
How do you replace a starter in a 1999 suburban
Take old one out put new one in
I have the check engine light on and the code is for map sensor on my 1999 1500 Chevy suburban
I have a 1999 Suburban-JB6 brakes. The drum size is 11"
See Ganderton's Answersearch for "How do you change power steering fluid". Hope it Helps.
Yes.
I have a 1999 Chevy Suburban LT and if I stay at the recommended hwy speed I easily get 19mpg
Just take it out and put the new one in. They are hard to pull out.
The 1999 Chevy Suburban camshaft sensor is located on the front of the engine. The camshaft sensor will be behind the front engine cover.
How do you change the oil filter sending unit of a 1999 suburban?