0
How do you change a reverse idler bearing on a 1988 Nissan Pulsar nx?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change wheel bearing on a N15 Nissan Pulsar back left?
take it to an auto repair shop .or buy another car .or not.
How do you change the tail light on a Nissan Pulsar N16?
buy a different model Nissan sucks!!!!!
How do you change the reverse switch on Nissan micra?
nissan micra 2006. how to change a reverse switch?
How do you change the battery in a 1992 Pulsar Nissan key fob?
if you cannot pop it open then you either contact Nissan or throw it in the lake?
How to change Altima 1993 rear wheel bearing?
Begin by removing the tire and wheel from your 1993 Nissan. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install your new rear wheel bearing.
How to change Nissan Pulsar n16 fuel filter?
It is under the back seat next to the fuel tank.
How do you change the power steering belt on a n15 Nissan Pulsar?
The power steering belt on the n15 Nissan Pulsar is located between the passenger cab and the engine. This is a difficult area to work on at home. It may be best to see a professional as exposure of the area is difficult to achieve.
How do you change the front wheel bearing on a Nissan x-trail?
In order to change the front wheel bearing on a Nissan X-Trail, one must remove the hubcap from the tire, thusly remove the tire from the car's axel, and then feel around for the wheel bearing and dislocate it.
How do you change a 1994 Nissan Altima wheel bearing?
take old out put new in
Can other Nissan alternators be used on a 91 pulsar?
Yes other Nissan alternaters can be used.The biggist problem you have is to fit it.The wireing of all alternaters are basicly the same but easy to change.
What causes a pulley to make noise on a 1992 Nissan maxima?
it is time to change bearing on that pulley
How do you change a front wheel bearing assembly in a Nissan Murano?
remove wheel,unbolt caliper assembly,remove rotor,take off axle nut and push in axle as far as it will go in,remove abs sensor attached to spindle,remove 4 bolts behind spindle attaches hub bearing. hammer out bearing . reverse to install
