Changing a thermostat on a 2008 Dodge Avenger can be difficult because there area two thermostats. One is located under the intake manifold inside a housing unit, and the second is at the end of the radiator hose.
If you follow the bottom hose on your radiator it will lead you to it. You will have to remove 3 bolts on the thermostat housing to get to it but it should only take you about 20 minutes to change it out.
No, Jiffy Lube does not replace thermostats. They only perform preventive maintenence services. You will have to go to a full service shop, such as Firestone or NTB to have a thermostat replaced.
where is thermostat located on Camry
If you follow the bottom hose on your radiator it will lead you to it. You will have to remove 3 bolts on the thermostat housing to get to it but it should only take you about 20 minutes to change it out.
There are two thermostats in the plastic housing on the driver side of the cylinder head. It needs removed to access them. Replace all seals, fill coolant, and warm up engine.
The thermostat on a 94 Kia Sephia is located in the thermostat housing which is clamped to the radiator hose. To change it, remove the boltsÊon the thermostat housing, pull the thermostat out and replace a worn gasket. Ê
Drain the coolant, remove the alternator and the etc. sensor hose from the reservoir. Remove the housing and replace the thermostat.
thermostat is located under radiator cap!
That's probably a good bet. Thermostats are relatively cheap and if you have a concern such as the one you describe, you should just change the thermostat.
To change the thermostat in this Lexus model, follow the upper radiator hose to the aluminum housing--the thermostat is located in that housing.
I did this last week on my 99 avenger. What you want to do is remove the air intake and the battery, they get in the way and make it hard to remove the covering. Next remove 4 bolts from the place where the thermostat is. mine was directly on the right of the engine. Take out the screws and remove the old thermostat. Insert new one and put everything back where you got it.
The thermostat should be located in the top radiator hose inlet at the engine. The hose and inlet need to be removed to change the thermostat.