0
To change the ignition on a 1997 Oldsmobile LSS, start by disconnecting the negative battery terminal to ensure safety. Remove the steering column covers to access the ignition switch, then disconnect the wiring harness from the ignition. Use a screwdriver to remove any screws securing the ignition switch, and replace it with the new one. Reassemble the steering column, reconnect the battery, and test the ignition to ensure it's functioning properly.
What else can I help you with?
What is the bolt size caliper for a 97 Oldsmobile lss?
27
How do you change supercharger oil on 97 Oldsmobile lss?
To change the supercharger oil on a 1997 Oldsmobile LSS, start by locating the supercharger's oil fill plug, usually found on the side of the supercharger unit. Remove the plug and use a pump to extract the old oil from the supercharger reservoir. Once drained, replace it with the appropriate supercharger oil, ensuring it's filled to the correct level as specified in the owner's manual. Finally, reattach the fill plug securely and check for leaks.
Why does the 97 Oldsmobile lss burn up transmissions?
The 1997 Oldsmobile LSS is known for transmission issues primarily due to design flaws and inadequate cooling. The transmission may overheat, especially if the fluid is not regularly maintained or if the cooling system fails. Additionally, worn components or poor driving habits can exacerbate these problems, leading to premature transmission failure. Regular maintenance and monitoring can help mitigate these issues.
Where is the ignition module 97 explorer?
Where is the ignition module 97 explorer
How do you change ignition switch on 97 ford expedition Eddie baur?
Do you mean the electrical ignition switch or the cylinder lock and key..?
What if your interior lights are not working 97 Oldsmobile delta lss Ive checked the fuses but there good any ideas?
On my Lss 1997 it was the Positive battery cable. It was making a good connection to start the car but it wasn't making a good connection to keep the interior lights on. May need to take the positive cable loose and see if one is corroded and either clean it or replace it.
How do you change the ignition coil on a 97 mark 8?
They are incorporated in each spark plug wire.
What is the torque specification for the lower intake manifold on a 97 3800 oldsmobile LSS and what is the sequence for tightening the bolts?
The torque specification for the lower intake manifold on a 1997 Oldsmobile LSS with a 3800 engine is typically around 18 lb-ft (25 Nm). The recommended tightening sequence involves starting from the center bolts and moving outward in a crisscross pattern to ensure even pressure distribution. Always refer to a service manual for the exact sequence and specifications, as they can provide the most accurate information for your specific vehicle.
Where is vacuum air control on 97 Oldsmobile lss?
On a 1997 Oldsmobile LSS, the vacuum air control system is typically located near the engine, often connected to the intake manifold. It controls various functions, such as the HVAC system and the operation of the engine's components that rely on vacuum pressure. To access it, you may need to remove some engine covers or components for better visibility. Always refer to the vehicle's service manual for specific guidance on locating and diagnosing issues with the vacuum air control system.
How do you change an ignition coil on a 97 sonoma?
pull the two bolts buy new or used ignition coil the replace the ignition coil is on th left side of motor right by the tbi
Steering and ignition locked on 97 cavalier?
The steering and ignition will become locked on a 97 Chevy Cavalier if the key is not inserted into the ignition and turned. This helps to prevent theft.
Where is the belt tensioner on a 97 Oldsmobile Aurora in order to change the Alternator?
just above the alternator wheel. there is a square hole on the top side of the tensioner.
