Hopefully you have the key for the ignition switch still. If you do you need to start by dissabling the air bag by pulling the fuse if your truck is equipped with one. After that you will need a very small screw driver or a stiff piece of wire ( like a coat hanger ). Put your key in the ignition and look underneath of your steering colum right below the ign switch. There should be a small hole that you can put the screw driver up into. On the bottom of your switch is a small spring loaded button that you have to carefully fish around in there until you depress. When you think you got it, gently turn your key forward and backwards while pulling out on the whole switch. sometimes it's easier if you have someone else working the switch while you try to hit the button. When you get everything just right the whole assembley should slide out. To reinstall you should'NT have to push the button in, just make sure the square male end of your new switch is turned to match up with the female notch that's in the colum.
ignition switch
on top of your steering collum.
should be red and light blue from the ignition switch to the starter relay
ok
how to replace the netural saftey switch
install ignition 2002 ford ranger directions
Possible bad ignition switch
Remove the retaining nut from the ignition switch. Pull the switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Do you mean the electrical ignition switch or the cylinder lock and key..?
No spark can be as simple as a ecm fuse blown, a bad ignition switch, defective ignition module or a bad coil.
take the steering wheel off and take the ignition lead off and then you buy a new ignition with new key or vis versa
Get a repair manual for your truck, because you will need to cut the wires out of the ignition switch, and bypass the alarm.