0
The switch is located on the left side of the steering column, underneath the dash. You will have to remove the lower dash panel and some of the ductwork to gain access to it. You will need either a 5/16" or 8MM driver to remove the two screws that hold it to the column.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How do you replace the ignition switch on a 1982 Mercedes 300SD?
To replace the ignition switch on a 1982 Mercedes 300SD, disconnect the battery and remove the horn pad. Locate the wire behind the horn and remove.
Where is the ignition switch relay on a 1982 Chrysler New Yorker 318 engine?
The ignition switch relay on a 1982 Chrysler New York with a 318 engine is behind the steering column. It is on the inner fender panel.
1982 Chevy celebrity?
OK, you have a 1982 Chevy Celebrity. Do you have a question?
Why would a 1982 Chevy van not turn off after the ignition is turned off?
It doesn't want to, It's not done running yet... :) Check the ignition timing with a timing gun. When the engine continues to run after it has been shut off the problem is known is dieseling, or pre-ignition. Hope that helps.
Will a 1983 Chevy 350 motor go in a 1982 Buick Regal?
Yes but you will have to change the Trans and also add Chevy motort mount brackest to the cross member.
Why doesn't your 1982 Toyota PU turn over or click when you turn the key?
Dead battery, loose or corroded battery terminals, defective starter, solenoid, or ignition switch.
Does a 1982 Chevy S-10 have a dimmer switch?
Yes, the dash light dimmer switch is located next to the headlght switch. You rotate it one way and the lights dim out, rotate it the other way and they get brighter, keep rotating it that direction and the interior light comes on.
What size engine is 1982 Chevy Caprice?
i had a 1982 Chevy caprice classic that had a 4.4 small V8 olsmoblie engine in it.
Where is the crankshaft sensor on a 1984 Chevy Celebrity 2.8L?
It does not have one. Crankshaft position sensors are used in distributorless ignition systems to tell the ignition control module where the crankshaft is in its rotation. The 1982 thru 1986 2.8L engines had distributors so they had no need of a crankshaft position sensor.
What year was the Chevy s10 introduced?
The Chevy s10 was introduced in 1982.
Problems starting your 1982 Chevy pickup?
If you are having trouble starting your 1982 Chevy pickup, common issues could be a weak battery, faulty starter motor, clogged fuel filter, or ignition system problems. It is recommended to check these components for any signs of malfunction and address them accordingly to resolve the starting issue.
Does a 1982 Chevy camaro Z28 have a warning chime when the key is in the ignition with the door open?
Yes, it should be located under dash on drivers side or on passengers side under dash to the right of the console
