use jumper cables put them from your car onto another car to keep power to the car while you replace the battery if you don't have jumper cables some light insulated wire will do too it is also possible to get a cigarette to cigarette socket charger makes doing the job bit easier just let the key on and the power comes from one car into yours through the cigarette lighter socket
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
Check battery, charge it or change it. Dead battery.
how do you change front headlight bulb on 2000 volkswagon cabrio
unhook neg battery cable then wait 10 mins for disgarge of capaciter then proceed to change ignition
First unhook the battery. Then put the key in (you need it!) and turn it to "on." Remove the steering wheel and the ignition switch just slides out.
can I switch ignition cylinder with a different ignition cylinder w/key in a 2004 chevy Malibu without having to use a passcode
An ignition coil is an coil that is used to change the volts in a battery to ignite the spark in the spark plug. This is necessary to get the engine to start up and the car to run.
The battery will recharge itself when placed in the ignition and the car is driven. I'm not sure how long it takes to completely recharge and I don't know if the battery is removable
Locksmith?
Disarm the alarm before removing the battery.
Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.
It might need reprogramming, but try this first.. 1. Disconnect the battery and leave it disconnected for 10 minutes. 2. Rehook the battery, then turn the igntion on without starting it. 3. Leave the ignition on for 1 minute, then try to restart it. It might take a while, but it should level out. Good Luck!!!