Inside the trunk, pull the grey feltlike covering away from the taillight area. The bulbs are held in individual holders that you turn about a quarter turn to release. You can then replace the bulb in the holder and put it back in the taillight assembly and turn the opposite direction until it clicks in place. A lot easier than having to remove the whole assembly to do like a lot of other cars.
The brake lights on a 2001 BMW 525i are replaced by removing the retaining screws, pulling the light assembly from the vehicle, and disconnecting the bulb. A new bulb is then put in place and reassembled.
The good news is the brake lights still appear to work even when this warning is displayed. Does anyone know if the brake lights are at risk of not coming on when you hit the brakes?
how can i reset rear brake pad warning light on 2006 bmw 525i
how do you change the starter on 93 525i BMW
The brake fluid reservoir on a BMW 525i is located along the right, rear of the engine compartment. It is connected to the power booster which aids in braking via vacuum pressure.
You put brake fluid in a 1990 BMD 525i in the brake fluid reservoir. This is more than likely located on the master cylinder of your braking system, under the hood of the car.
under the hood; under the flat panel labeled BMW. There are 6.
how do u change on board computer BMW 525i 1990 and need a diagram of relay switches
what kind of transmission fluid does a 1991 bmw 525i need
Yes !
You can add brake fluid inside the brake fluid reservoir. The reservoir is located on the driver's side under the micro-filter panel.
The 1990 325i has a M20B25 motor. The earlier 1990 525i had the same motor, a M20B25, whereas the later 1990 525i had a M50B25.