I can't answer your question, but I do have the answer: Buy a service manual from a parts store, of from Amazon. Surely you kept the owners manual??? Sometimes they show some tasks. (I prefer the Chilton SMs to the Haynes because of the line drawings used to illustrate most operations.
and you get it fixed before a cop notices!!!!
On this model there is usually 3 screws holding on the lens assembly.
two are on the side of the assembly towards the front and one between the bumper and the car body. Once removed the unit should come back so you can change the bulbs
remove the 2 screws from the red plastic and gently pry the red cover off.
adjusting Isuzu rodeo brakes
Check the bulbs they are double filamented with smaller being for brake lights
abs codes are retreved by juming obd2 terminal 4-12 after codes plump brake petal 6 times
Did you check the drive belt to see if it broke?
I don't think that will work unless you change over to rear disc brakes, the hub should not match.
replace stop light switch
when all three of those lights turn on that means that your alternator is bad. i just went threw this same problem with my rodeo
How to Install Front Brake Pads Check Related links below.
There is a third screw between the brake light and the bumper.
its either a bad caliper or the the brake hose itself could be bad
It means the Anti Lock Brake system isn't working properly
it took me forever to figer out but i have a 96 rodeo manual and the e brake has to be up and if it don't work id check the fuse panels
On the rear wheeels. some have a special drum inside the rotor and some use the caliper.
This part is located on the firewall on the driver's side, right next to the brake booster.
There should be a small resivor by the brake booster on the driver side of engine compartment for clutch fluid.
If the bulbs are in good shape but the brake lights dont come on when you step on the pedal then I would say you have a bad stop light switch. It is located on the upper part of the brake pedal. If you look under the dash, just follow the brake pedal and you will see it. It should be an overall easy replacement.
To change the brake lights on a 1997 Volkswagen Polo first locate the brake light housings in the trunk. Remove the plastic covers and unlock the bulbs. Remove the bulbs and install the new brake lights.
change the brake lights check the fuse check the brake light swtch
When you replace the brake light bulb on your Rodeo, be careful not to touch the bulb directly with your fingers - the oil from your skin will cause the area that you touched to burn hotter than the rest of the bulb, which causes the bulb to burn out quicker.If you are going to replace a bulb in your cluster, it is a good idea to replace all of them. Not only will the lights on your Rodeo be brighter, you decrease the likelihood you will need to change any of the bulbs again in the near future. A burnt out bulb in the taillight cluster of your Rodeo is an excuse for a police officer to pull you over. Check your bulbs frequently and change burnt bulbs promptly.
The brake lights are accessed through the rear hatch. Find the panel on the rear sides of the car. Pop out the panel and access the brake lights. Replace the bulbs.
it would be the brake light switch about 20 dollars at autozone
change the fuse if not replace flasher
If its the bulb you have to unscrew the light cover and pull out the old bulb and put the new one in.Then screw the cover back on.