answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change brake pads on a 1997 Oldsmobile Achieva?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the blower motor located on a Oldsmobile achieva?

where is the blower motor located a a 1997 oldsmobile achieva


Where is the oil filter located on a 1997 Oldsmobile Achieva?

Which engine is in this car?


Where is the transmission shifter interlock solenoid located on a 1997 Oldsmobile Achieva?

The transmission sifter interlock solenoid location on a 1997 Oldsmobile Achieva is on the valve body. To reach it the drain pan and filter has to be removed.


How do you set the timing on a 1997 Oldsmobile Achieva AL?

The timing is computer controled and not setable.


Wiring schematics for 1996 Oldsmobile achieva?

I have a 1997 Oldsmobile Achieva. I use the schematics in the Haynes manual I bought for my vehicle. There are several wiring diagrams in the manual, so you have to match your vehicle to the appropriate diagram.


Where is the turn signal flasher located on a 1997 Oldsmobile Achieva?

Under dash on driver's side


Where does a thermostat go on a 97 oldsmobile achieva SL?

The thermostat on a 1997 Oldsmobile Achieva SL goes on the very bottom of the water pump. It is inside the top hose of the radiator on the end that attaches to the water pump.


Where is the airbag module 1997 Oldsmobile achieva the light will not go off.?

The 1997 Oldsmobile airbag module sensor can be found below the dashboard on the drivers side. The airbag module should be labeled as such.


Where is the turning signal flasher fuse located on a 1997 Oldsmobile achieva?

leftof steering column behind i/p


What is the brake fluid specs for 1997 oldsmobile 88 LSS?

Use only DOT3 brake fluid.


How do you change the headlight on a 1997 Oldsmobile Cutlass?

There


Where is the thermostat located on a 1997 Oldsmobile Achieva?

follow the top radiater hose to where it goes to the motor there should be a bubble looking metal houseing if it is it will be inside.