How do you change cabin filter Hyundai xg350l?

Answer 1

To remove existing filter: 1. Open the glove compartment, locate and remove the spring-loaded stop cord on the right hand side of the glove compartment. This is done by slightly pulling the cord into the glove compartment then feeding it back through the hole. It is spring loaded but will park in an easily reachable position. 2. Locate and remove the rubber stoppers on each side of the glove compartment and remove by pulling them out on the leading edge and slide them toward you. 3. Swing the glove compartment door down to the floor. 4. Locate and remove the 10MM bolts one each side of the lower portion of the panel behind the glove compartment. 5. Locate and remove the Phillips head screws one on each side of the upper portion of the panel behind the glove compartment. There is also one on the lower right side.

6. Locate and remove the 10MM nut located in the center portion of the panel. 7. Carefully pull out the glove compartment panel releasing the two locking clips and disconnect the two electrical connections. 8. Remove the bottom panel by carefully releasing the two locking clips and a tab that hooks onto the front lip of the blower housing. 9. Locate the filter access door and remove by pulling down and outward on the bottom lip. 10. Pull the dirty cabin filter out by the small handle located in the center of the filter. 11. Install the new filter paying close attention to the airflow directional arrows. 12. Reverse the procedure to complete assembly