answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change citroen Picasso idle pulley?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can a citroen xsara picasso idle control valve make your engine rev to much?

Most certainly it does!


How do you adjust the idle speed on a citroen berlingo 1.9d?

How do you adjust the idle speed on a citroen berlingo 1.9d (basic diesel engine)


Where is the citroen xsara Picasso idle control valve?

it is a the rear of the air intake...right at the back /top of engine..you have little room to take out two srews ....it will have a plug lead going to it. this is on a 1.6


On a citroen xantia What is the correct idle speed?

850 RPM,


What is a idle pulley?

idle pulley is a pulley on an engine that does not drive any accesories ,such as water pump or alternator. it is put there to route the belt so as the belt will not hit or rub on other parts or accesories


Why does your citroen c2 keep stalling when in idle eg at lights or approaching a roundabout?

idle control valve is shot!!


Why does the Citroen Xantia 1.8 keep stalling when the car idles?

you need to replace the idle regulator and re initaiise it. idle regulator needs to be replaced and then reinitalised via a suitable diagnostic tool.


What is the signs of bad idler pulley Chevy ZR2 2000?

The idle or pulley will have movement in it, when the engine is shut off. It can also have a visible wobble while the engine is running.


Where is the ac compressor located on 1993 infinity j30?

it is located to the right of the fan at the bottom.next to the idle pulley.


Where is the pulley to tighten up belts?

theres gonna either be a tensioner bolt or tensioner pulley... u should beable to locate waterpump, crank, a/c, alternator, powersteering,idle pulley. knowing the car woulda been easier


Why is your idle pulley busting serpentine belts?

Because the bearing in it has worn out and it is locking up causing the belt to break.


How do change idle on 2000 galant?

bISS iDLE SCREW ON THE THROTTLE BODY