Mercury Grand Marquis
DIY Projects

How do you change front shocks on 1993 mercury grand marquis?

123

Top Answer
User Avatar
Wiki User
Answered
2014-11-20 05:13:00
2014-11-20 05:13:00

The 1993 Mercury Grand Marquis does not have front shocks. The Mercury has front struts. Compress the strut spring with a spring compressor. Remove the strut retaining bolts. Reverse the process to install the new front struts.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


It has gas pressurized shocks in the front and rear.

assuming you mean the light bulbs, see the answer to "how do you change turn signal lamps both front and rear on a 96 mercury grand marquis" right here in WikiAnswers.

how to change front shocks in 01 Chevy s10

how do you replace the front sway bar likn in a 1999 Grand Marquis?

(Licenced Technician) -- 1990 Mercury Grand Marquis does not use struts. It uses coil springs with separate shocks for the front and rear - except for some of the upscale trim Grand Marquis models, which run computer-controlled air suspension in the rear. Why are you wanting the "struts" changed? Are you having handling problems? Does the car sit low on one side? I have owned a 1991 Crown Vic and a 1989 Grand Marquis; front shocks are not really difficult (for me) to change; front coil springs are much more difficult. These cars were known for sometimes breaking coil springs. Unless you have a good solid garage floor, a couple of floor jacks, a complete set of line-up bars, and access to air tools, I would not recommend doing this job yourself. Hope this helps.

Struts on the front , but motorcraft.com lists shocks and struts for the back ( I'm confused ! )

Open the trunk and turn the switch off that says air ride. Or the button might also b on the front passenger side kick panel.

The rear are shocks the front has struts. Rears shocks are a snap to change. Front struts should only be changed if you have the proper tools and knowledge as it can be dangerous.

you dont need to remove coil springs to change shocks just remove 2 bolts on the bottom of the lower control arm and 1 at the top the shock goes up thru the center of the controlarm and the coil spring

firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis

you cant change the front shocks on the trailblazer without a spring compressor because on a trailblazer they all have struts and they have to be compressed down

its on the passenger side front near the front tire

firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis

firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis

It will be easier if you pull off the front tires then you have the shock bolts at your reach. It took me 30 min for both front shocks.

firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis ( V8 )

Go to Car-Part.com and you can find many many seats for this car

firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis

On a 2004 Mercury Grand Marquis : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle

At the front of the engine , towards the drivers side of the engine ( power steering fluid reservoir on a 1998 Mercury Grand Marquis )

On a 1995 Mercury Grand Marquis : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle

If your Mercury Grand Marquis is a 1991 model or older . The 5.0 liter / 302 and the 5.8 liter / 351 has the distributor at the front of the engine The distributor rotor turns COUNTERCLOCKWISE

On a 1999 Mercury Grand Marquis : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle

On a 1998 Mercury Grand Marquis : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.