To change the heat resistor on a GMC Safari van, first disconnect the battery to ensure safety. Locate the resistor, usually found near the blower motor under the dashboard, and remove any necessary panels for access. Disconnect the wiring harness from the resistor, unscrew it from its mount, and replace it with the new resistor. Finally, reassemble any panels, reconnect the battery, and test the heating system to ensure proper function.
how u change spark plugs on 1998 gmc safari van
How to remove pentium cover on a 2000 gmc safari
Installing this part in a 1998 GMC Safari or Chevy Astro requires enlarging the hole in the duct where the resistor is mounted. I did this using a utility knife with a new blade installed. I don't think that it is possible to safely modify the resistor module to fit in the hole provided when the vehicle was manufactured.
you have to remove the intake to get to them.
You need to replace the blower motor resistor. I've been there done that.
The heater resistor pack in a 1995 GMC Safari is typically located under the dashboard on the passenger side of the vehicle. You may need to remove the lower dash panel to access it. The resistor pack is usually mounted to the heater box and connected by a wiring harness. If you're having trouble locating it, consulting a repair manual specific to your model can provide further guidance.
GMC safari has twoconverters
On a 1992 GMC Safari van, the heater resistor is typically located in the HVAC housing, which is situated under the dashboard on the passenger side. You may need to remove the lower dashboard panel to access it. The resistor is usually mounted near the blower motor and can be identified by its connector and several wire leads. If you're having trouble locating it, consulting the vehicle's service manual can provide specific guidance.
I had an 89 safari and the only way I could change plugs was from underneath and you need a swivel to get them from there
Where do I fill the transmission fluid gmc Safari van?
Drop the glove box door; I believe you will then be able to see it. when you drop the glove box. the dog house is there. this is a van.
On my 1998 gmc safari the ignition module is located next to the ignition coil it is attached to a heat sink lift the inside engine cover off it's on the passenger side top middle of the engine.