How do you change ignition switch on a 1992 econoline 250 ford van?
best to go to a experienced mechanic-one who deals with auto keys
there are wired involved
Why would the heater wipers and lowbeams on a 1992 VW Jetta not work but when holding highbeams on everything works?
First you need to take off your horn cap. Then take a 13/16 socket to loosen the steering wheel. Take a steering wheel puller to get the wheel off. After that you need to get a lock plate compressor to push the plate down to remove the snap ring. (There is a tool for this but it can be taken off by a flat head screwdriver. Now you need to undo the screws in the…
All instruments have gone dead on 1992 320i apart from ignition battery and oil lights when key is turned?
To replace Ignition Switch, first you have to remove the old one. To do this you disconnect battery ground cable. Remove the upper steering column shroud by removing the five self-tapping screws. Remove tilt steering column lock lever, Remove lower steering column shroud, disconnect the ignition switch electrical connector, turn ignition switch lock cylinder to the "run" position, remove the two screws retaining ignition switch, and finally unhook the ignition switch from the actuator. Now…
1992 Ford Mustang recently the signal lights stopped working you have checked the fuse and bulbs all are good and not blown What else can be at fault?
Why does a 1992 Chevy lumina sedan start when crossing the two post at the soliniod but not by turning the key?
My boyfriend and I just did this in his Ford E150. You have to remove the steering wheel (several autopart stores rent steering wheel removers). From there you can see the ignition switch. The ignition switch cylinder is about 4 inches long, and projects into the steering column. All you have to do is press a small tab, then pull out the ignition switch. New ignition switches (with keys) are available at autopart stores. I…