Where your license plate is on the back. If you hold the hatch back door at eye level you will see a black release button that you slide to the left if your replacing the passenger rear and it's kinda tricky because you have to slide it as you are pulling it out.( I used a screw driver to help me pull it out) If you are doing the drivers rear license lite ( I had to unscrew the screws that are in the way because it wouldn't let me slide it enough to pull the socket out. But if you go look at it you'll see what I am talking about. Hope this HELPS :)
how do u change the license plate light on a 2005 sienna
how to replace drive belt on a 2005 ford escape XLT 3.0 V-6
how to change 2005 equinox license plate light i removed the screws but it didn't release
I just did my 2005 Ford Escape front brakes and the caliper was 7mm Allen and main holder is 18mm ...RRR Wis.
check a car website
I just found the block heater on my 2005 Ford Escape. It is tucked up in front of the radiator (by where the front license plate would be if it had one) The owners manual, however, said (if equipped) so they may not all have one.
The 2005 Ford Escape owners manual shows : ( 6 quarts with filter change ) for the 3.0 L Duratec V6 engine
The 2005 Ford Escape owners manual shows : 4.5 quarts with filter change for the 2.3 L - 4 cylinder engine
To change headlight bulbs in a 2005 Ford Escape, first make sure the light switch is in off position and replace the passenger light bulb. Next, get to the driver's side bulb, remove the battery by holding it down, to be able to change the headlight bulb.
Be My Escape was created in 2005.
The 2005 Ford Escape has 16 valves.
The 2005 Ford Escape is a gas-powered vehicle.