Want this question answered?
You can try, but it will not stay. The heating and cooling of the manifold will cause the JB weld to fall off.You can try, but it will not stay. The heating and cooling of the manifold will cause the JB weld to fall off.
this sounds alot like a turbo failure, although there could well be a leak in the pipes leading from the turbo to the intercooler, or from the intercooler to the inlet manifold. also check the intercooler for leaks. or it is the vacuum pipe that operates the waste gate on the turbo, or a seized waste gate.
From experience with various Typhoon and Syclone owners I can tell you that the transmission will snap under harsh acceleration. To make the list short, transmission transmission mounts transmission oil lines front lower intercooler front lower intercooler pump wiring radiator thermostat exhaust manifold leak intake manifold leak wheel cylinders (rear) wheel axle seals (rear) caliper bolts stock exhaust system
Yes you can. I'm not sure of your knowledge of this so I'll say alot You can get a turbocharger for anything, as long as it is done the right way. What you will need will be an exhaust manifold with a turbo flange on it. This flange must fit the size turbo. (t25, t3-t4). It should be clearly stated on information on the manifold. You will need a wastegate.... depending on the turbo. If it is internal, you don't, external, then yes. Piping- from turbo to intercooler and intercooler to intake manifold Intercooler, to mount on front of truck behind bumper. probably smaller one for ranger. air to air intercooler... blow-off-valve- mount as close to intake manifold. Boost controller and Boost gauge. To monitor and change pressure. (keep below 7psi (7psi is a pretty well know threshold for stock engines) on engine with stock internals) that is the basics..... also might want to upgrade fuel and cooling system to keep up with the performance of the new mods...
The exhaust manifold needs to have a gasket in place to help seal the juncture between the manifold and the engine. After the gasket and gasket sealer are in place, tighten the bolts for the exhaust manifold. The exhaust pipe can then be replaced on the new exhaust manifold.
The purpose of the exhaust manifold is to connect the exhaust ports on the cylinder head to the exhaust pipe.
exhaust manifold is where exhaust pipe hooks to engine!
This switch is located above the starter solenoid and the exhaust manifold!
This switch is located above the starter solenoid and the exhaust manifold!
In the exhaust manifold behind the engine.In the exhaust manifold behind the engine.
on the exhaust manifold in front of the engine right behind the cooling fans and in the exhaust pipe in front of the catalytic converter
bigger intercooler bigger intake manifold cold air intake header back exhaust chip it usual rice mods. odd question