undo 4/5 screws around petrol cap and remove.
you have to remove the frot cover,and so you can see the two units
were is engine cover wot does it do
Changing the pollen filter on a citren c4 grand picasso is an easy tenh minute job. First unscrew and remove the cover on the air duct. There is your filter. Just remove and replace.
behind nsf wheel on end of gearbox end cover 19mmplug head
To remove the steering column cover on a Citroen Picasso, first disconnect the vehicle's battery for safety. Then, remove any screws or fasteners securing the cover, typically located underneath the steering column. Once the screws are removed, gently pry apart the two halves of the cover, being cautious not to damage any clips or connectors. Finally, lift the cover off to access the steering components.
underneath the engine cover there is a long black box about 2" wide held by three bolts the plugs are under that
Remove the fuse board cover at the right hand side of the steering wheel, the switch is located behind the mass of cables, a quarter turn to the left will allow the switch to be removed.
From memory on my 1.8L Picasso Start off by disconnecting the battery following the special procedure The top of the engine is hidden by a plastic cover. The plastic cover is unfastened via three screws which need to be turned through 90 degrees. Then you have to detach the cables from and unscrew the coils (two bolts ?) This gives access to the spark plugs
under the bonnet there is a black plastic cover on the gearbox side, it has a + symbol on it connect positive jumplead to that and other engine mount or other earth
Air filter is on the right hand side of engine bay.Undo 4 screws on black cover at end of air inlet duct .
To change a relay in a Citroen Xsara Picasso, first, ensure the vehicle is turned off and the keys are removed from the ignition. Locate the relay box, typically found in the engine compartment or under the dashboard, and identify the faulty relay using the diagram on the cover. Using a pair of needle-nose pliers or your fingers, carefully pull the old relay straight out from its socket, and then insert the new relay, ensuring it is securely seated. Finally, test the system to confirm that the new relay is functioning properly.
If Your sitting in the drivers seat, theres a little cubby hole with a cover down to your right hand side. Your colour code is located on a sticker on the back of this cover.