I finally figured this out on my 1981 CJ7 with the 258 inline 6 engine. If your Power Steering bracket is like mine, the slot for adjusting the power steering pump belt tension is molded into the aluminum power steering bracket. Three bolts need to be loosened. Two bolts are directly opposite from each other and act as the pivot point. The third bolt is closer to the engine and goes all the way through the bracket. This third bolt is the adjusting bolt. The aluminum bracket contains a slot all the way through which the third bolt goes, allowing the entire bracket to be rotated using a 1/2 in. socket wrench in the square hole near the pump fill cap. You can't actually see the slot since it's covered up on the ends by other brackets. By loosening these three bolts, the tension can be released on the belt, allowing it to be removed.
How do you change a power steering pump in a 98 jeep cherokee?
How do you change the steering shaft in a 1990 Jeep Wrangler?
Some do
you must remove the steering wheel and turn signal from column. then you can acces the screw to remove the switch.
under the hood by the steering box
Plain regular power steering fluid.
Regular old power steering fluid.Regular old power steering fluid.
Yes
yes
remove old belt install new belt you're welcome
You should use power steering fluid in the power steering pump of the Jeep Liberty according to the owner's manual. Many people say that they prefer transmission fluid because it tends to be somewhat thicker.
No.