open up the boot and ten take out all carpet that is lying on the floor of the boot .then get a cross -head arewdriver and take out the srews out of the back of the light .as you are doing this you should also hold on to the rear brake lights as well .then go to your local garge and get areplaement kit from the make sure there red bulbs not white .the srew in new blubs and replace rear brake light cover and tighten with srew driver.
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
It could be the brake light switch, usually mounted on the brake pedal.
How do you reset dashboard brake light on vw passat
Peel the carpet from behind the light. You'll be looking at a white block with wires coming out of it. About midway down on either side there are tabs. Squeeze the tabs and pull.
The light assy has to be removed and the bulbs removed from the back.
Remove the two screws that hold the lens on, remove the lens and change the bulbs.
The brake light bulbs ar removed from the rear of the light assy . Take it off of the body.
If you mean the brake light, you just have to change the bulb or bulbs.
Brake Light ColorMine are clear bulbs ["white"] light, but the bulbs are mounted in an assembly with a red lens.
Brake Light ColorMine are clear bulbs ["white"] light, but the bulbs are mounted in an assembly with a red lens.
Headlight bulbs, high and low beam, parking light bulbs, signal light bulbs, brake light bulbs, dash light bulbs, interior light bulbs, plate light bulbs, etc.
I assume you only need to change the bulbs. Go into the trunk and look up. You should see the wires leading to the mounting point for the third brake light, you candisconnect the connectors and then change the bulbs this way.