0
Remove brake caliper and caliper frame, then take out rear spindle and remove bearing from it. Refit new one opposite way.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you change rear wheel bearing on 1999 alero?
How do you change rear wheel bearing on 1999 alero?
How do you change a wheel bearing on a 1999 Mercury Cougar?
Remove the tire and wheel from your 1999 Mercury Cougar. Remove the axle end. Remove the wheel bearing retaining nuts. Remove the wheel seal and the wheel bearing. Reverse the process to install your new wheel bearing.
How do you change a rear wheel bearing for an Audi a6?
How do u remove te rear wheel bearing on a 1999 Audi A6 Quattro
What might be causing a whining sound from the left front ABS sensor area of a 1999 Taurus wagon?
Could be a bad wheel bearing
What is cost of replacing front wheel bearing on 1999 Ford Taurus?
Around $75 in parts and $100-150 in labor all varies
How do you replace the front wheel bearings on a 1999 Dodge Avenger ES?
Begin by removing the tire and wheel from your 1999 Dodge Adventure. Remove the end of the axle. Remove the wheel bearing retaining nut. Remove the wheel bearing seal and remove the wheel bearing. Reverse the process to install your new wheel bearing.
How do I change the front wheel bearing on my 1999 VW Passat?
get some airforce dudes to do it for you and pay them it isn't worth it
What is the wheel bearing torque 1999 S10?
90psi
Change rear wheel bearing 1999 ford escort zx2?
Its easy Pull the wheel off you will see a center nut undo it and pull it off repace
Can you grease wheel bearings on 1999 Ford Taurus?
The wheel bearings in the 1996 and newer Taurus / Sables cannot be greased.See "Related Questions" below for information / procedures for replacing wheel bearings.
Will a wheel bearing set off a low tire pressure light in a 1999 Oldsmobile alero?
No, a wheel bearing should not set off a low tire pressure light in a 1999 Oldsmobile Alero.
How do you change a wheel bearing on a 1999 mercury mountaineer?
Take brakes off and then remove 3 bolts from back of spindle and slide it out. easyest I ever did
