Get a clip, shhding.com
to get a dime out of the seat belt area of a 325i, I have used a stretched out paper clip or a metal finger nail file. Be patient and slide it on out!
i actually wanted to do the same thing, so i grabbed the seat belt clip, the part that accepts the seat belt itsself, and removed the wires, by cutting them. then now my belt alert does not come on, its tricked into thinking that the seat belt is constantly on. just cut the wires.
For about 10 bucks you can get a clip. go to shhding.com
The belt part is attached to the seat frame and comes out with the seat. The track part is better left to a professional.
== ==
You can get a clip that should do the trick, for about 10 bucks. It's called a shhding. Go to shhding.com
yes it is possible, I have done it myself already. take 2-3 screw off the panel were the seat belt runs through and just unplug the clip wire and that will take care of it for ya.
there are two clips along with bottom part of the back seat....pull it out and release it. and then you will find there are two screw on both sides next to the seat belt clip. unscrew them and push the seat up.....job done!!
the easy way is to un clip the seat the clip is located under the front seat cushion by filcking the wire clip back its a wire clip lift cushion off then there are four bolts which unbolts seat to frame you will need to unplug wiring for seat motor you will see when you remove cushion then lift seat out
Make sure you are not latching it into the buckle for the middle seat belt.
Coins stuck in the seat belt clip will cause the seat belt to get stuck, I use a very sturdy piece of metal to place behind the seat belt buckle, a socket a little smaller than the push button and a hammer to get it unstuck "you get the picture" and it works every time for me. Pull out the coins " most likely" and you got working seat belts again. I hope this can help out a few fellows out there.