0
I have a 1995 Chevy Blazer assembled in April of that year. With this model, to access the actuator you need to disconnect and remove the battery as well as the plate on which it stands.
This will reveal the actuator. The cable is connected to the actuator by a spring clip. Carefully pull the clip out of its slot and move it a little to the left or right.
The body of the cable is held in place by a clamp. Using pliers, squeeze the two sides of the clamp and the cable will come away.
There are two bolts under the wheel arch which hold the actuator bracket in place. Remove them and you can now remove the actuator from the bracket.
Keith Perritt
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
1993 Chevrolet Blazer 4 wheel drive does not engage?
Need to put truck in 4x4 with engine off, transmission in park key onTake a test light and check the wires on the Actuator, and see if they are hot.If they are hot Then replace the 4x4 Actuator in the front housing.If they are not, Then check the 4x4 fuse
Will a4.3 vortec out of a 1993 S10 2 wheel drive fit in a 1995 blazer 4 wheel drive?
yes it will
How do you change an ignition module in a 1993 Chevy blazer?
your a fatty
Why won't a 1993 silverado pickup go into 4 wheel drive?
On Chevy there is a actuator that sits on the front axel that go,s bad you unplug the wires an unscrew the actuator that run about 114.00 dollars
1993 blazer the electronic switch for 4 4 indicates its in 4-wheel but its not is this a vacuum issue or should i be looking somewhere else?
I think I answered this question a couple of weeks ago although it was worded differently. I just had the problem you describe and it was caused by a leaking vacuum actuator on my front axle. The actuator is located under the battery box which has to be removed to get to the actuator. The job took the shop I took mine to about a half an hour. You might have a bad or disconnected hose to the actuator, this would be the place to start troubleshooting your lack of four wheel drive, other options take more expertise and shold be left to a professional transmission shop.
How do you set the timing on a 1993 full size Chevrolet blazer four wheel drive with 350 engine?
how do you set the timing on a 1993 Chevy pick up
Where are the sparks plugs located on a 1993 Chevy blazer?
if you have to ask this question, then you shouldn't attempt to change them...
Do you have to drop the tank to change the fuel pump S10 blazer 1993 do you have to drop the tank?
Yes.
What is the best tire size for 1993 Chevy Blazer S-10?
stock size for this vehicle is 235 75/r15 on a 15x7 wheel.
Will a automatic transmission from a 1992 blazer fit in a 1993 blazer?
yes
How do you install a heater coil in a 1993 full size Chevy Blazer 4 wheel drive?
I found the answer on AutoZone.com There was a section on repair info and then go to Heater Core GM Blazer/Jimmy/Typhoon/Bravada 1983-1993 Repair Guide. It has a detailed guide and pictures. Good Luck!
How do you replace front fenders on 1993 S10 blazer?
To replace the front fenders on a 1993 S10 Blazer, unscrew the bolts holding the old fenders in place. There are also rivets that have to be removed around the wheel well on both sides. The bolts are located inside the hood area on top of the fender.
