0
Not familiar with the "4R" designation, but there are really only 2 'popular' speed sensors:
- ABS wheel sensor
- Vehicle speed sensor
Both are well covered in the "Related Questions" below
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Does a 2001 Chrysler Town and Country have a Vehicle Speed Sensor?
yes the have a speed sensor a input and out put the input allow your transmission to change gears and the output speed sensor allow your speed to register on your speed domitor
Where is the speed sensor on a 2001 Ford Expedition?
Speed sensor on a 2001 ford expedition
How do you change the speed sensor on 2001 Escape XLT?
If it is the rear sensor, it will be in the differential. If it is a front sensor, it will be located at each front wheel.
Where is the crank position sensor on a 2001 ford windstar?
The crank position sensor on a 2001 Ford Windstar van is located on the bottom of the engine. It constantly monitors the engine's crankshaft and reports information to the computer.
Looking for chevy venture 2001 speed sensor that is located in the transmission?
where is the speed sensor for the transmission located in 2001 chevy venture
Where is the input speed sensor on 2001 dodge ram 1500?
There isn't an input speed sensor.
How do I replace the output shaft speed sensor on my 2001 Kia Optima?
where is the output shaft speed sensor located on a 2001 Kia Optima?
How do you change the thermostat sensor on a 2001 Chevy cavalier?
how do you change a thermostat sensor in a 2001 Chevy cavalier and where is it
What is the speed idle control on a 2001 ford f150?
Speed Sensor The sensor is located on the rear axle housing.
Is there a speed sensor on a 2001 dodge ram 5 speed tramsmission if so where is it located?
No speed sensor on the manual trans. The speedometer signal comes from the rear axle speed sensor.
What is an ALC sensor?
how do you change ALC sensor on 2001 Grand AM
How do you change abs speed sensor on a 2001 Nissan maxima gle?
Remove the wheel Trace the speed sensor from behind the rotor to a connector disconnect the connector unscrew the bolt that's attaching the sensor to the rotor platform You might have to pry the sensor from the rotor platform geraldfulsom34@yahoo.com
