Hey TammyIt is at the rear of the intake manifold and is that big shinny round thing. Remove the vac line then the 2 bolts that hold it on. Clean where it mounts and install the new one. GoodluckJoe
ACTUALLY IT DOES NOT HAVE A VACUUM LINE TO IT AND IS RIGHT BESIDE THE BIG AIR TUBE THAT GOES TO THE ENGINE. iT HAS A PLUG ON TOP OF IT WITH 4 OR 5 WIRES GOING INTO IT. TWO BOLTS HOLD IT ON tHEY ARE 10MM SOCKET BOLTS. vERY EASY TO CHANGE
Once off, usually you can just use some carb cleaner to make sure it is free and screw it back on so you don't have to buy a new one.
How do you change bulb on 1996 saturn
where is the evap purge valve located in a 1996 jimmy
The EGR Valve on the 1996 Mitsubishi Galant is located underneath the Exhaust Manifold.
Where is the EGR Valve on a 1996 Mazda Protege located at?
The bleeder valve is a 8mm bolt for the rears located on top of the drum or on the caliper itself if you have disk rear brakes. For the front, a 10mm bolt is located on the caliper itself. PB blaster should be used to be sure the bleeder valve is not broken
The water pump on a 1996 Saturn sl2 is located in the engine compartment. It sits below the AC compressor.
how do i remove the valve cover to change the gasket in a toyota camry 1996
The PCV valve on a 1996 Ford Escort 1.9L is located between the engine and the radiator. It is near the vacuum hose.
A 1996 Ram does not have EGR
You replace the valve seals on a 1996 Saturn SL1 by removing all of the hardware to get to the valves, unseating them, cleaning them, and sliding the new valve gaskets on. In order to do this you should consider getting a good Chiltons or other repair manual for your make, model, year, and engine.
The thermostat is usually located on the lower hose, where it attaches to the radiator
Located on the fuel rail drivers side
I think the best way to find out is to go to the nearest Saturn dealer and ask the auto department where it is located. They won't charge you for location of part.
most all pcv valves are located on the valve cover
The EGR valve is located on the drivers side of the head, just above the transmission bell housing. Remove the electrical and vacuum connections, then remove the two bolts that hold the EGR valve to the head. Use a NEW gasket when replacing the EGR valve.
It is on the driver side, behind headlight.
On a 1996 Chevy Camaro, the PCV valve is located on the right side of the valve cover. There is a hose that runs from the PCV valve and connects to the back of the intake manifold.
The egr valve is located on the top of the engine on the right hand side
On top of the valve cover , near the rear of the cover
It is in a hose that is stuck in the top of the drivers side valve cover.
The AC low pressure valve on a 1996 Isuzu Rodeo is located in the back of the engine compartment. The valve is on the larger of the two hoses that run from the evaporator to the compressor.
It is located under the power steering. It's only access is from underneath the car.
It is located on the Left Side ( facing the engine) by the Alternator.