0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the voltage regulator on a 1986 Honda Prelude?
Most vehicle manufacturers now put the regulator inside the alternator.
Does 86 Honda Prelude have clutch cable?
The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.
What engine do you have in your1986 Honda Prelude 2.0si?
The 1986 Honda prelude 2.0 Si has a A20a3.
1986 Honda prelude transmission fluid?
peace89
How do i fix a low idle on a 1986 Honda prelude 2.0 si?
my Honda prelude 1986 si wants to cut off after its warmed up . any sugestions on what ot could be
How do you remove a rear strut on a 1986 Honda Prelude?
inside the trunk?
Where is the voltage regulator on an older 1986 Honda Prelude?
is inside the alternater
Where is the voltage regulator on a 1986 Honda Prelude carb engine 1.8?
it is inside the alternator. If the voltage regulator goes bad you have to change the whole alternatorAnswerIn your 1986 Honda prelude the voltage regulator should be separate from the Alternator. It should be a small black square with a five wire connector if i remember right. It should be mounted on the passenger side strut bubble inside the engine bay. Between the battery and the strut bubble and between the under hood fuse box and the engine. It is held on by two 10mm bolts. I know that this is where the voltage regulator is on my 1985 Honda prelude with the 1.8l carbed engine and since the 84-87 were mostly the same it should be the same on yours.
How do you clean the carburetor on a 1986 Honda Prelude?
Make sure your computer has no viruses
What does PGM-FI mean on a 1986 Honda Prelude?
Programed Fuel Injection
Where is the horn located on a 1986 Honda prelude si?
On the crossbars of the steering wheel.
Can you change the computer in a 1986 prelude si to get more power out of a 2.0 fi motor?
The computer on a 1986 Honda Prelude Si can be upgraded but the harness will need to be updated as well. This is done using a wire harness conversion kit. The kit will allow for a tunable ECU.
