answersLogoWhite

0


Best Answer

1)Detach the negative cable from the battery. (CAUTION) If the factory stereo is equipped with an anti-theft system, make sure you have the correct activation code before disconnecting the battery. 2)Detach the electrical connector and any ground straps from alternator. 3) Remove the fresh-air duct and the splash shield under the front of vehicle. 4) Unbolt the A/C compressor and set it aside, but don't disconnect the hoses. 5) Loosen the alternator adjusting bolt and tensioner bolt, then detach the drive belt. 6) Make sure the new(rebuilt) alternator looks identical to old one. Many new or rebuilt alternators don't have a pully installed, so you may have to use the pully from the old alternaor. 7) Installation is the reverse of removal.HAVE FUN ! -CE

Answer1)Detach the negative cable from the battery. (CAUTION) If the factory stereo is equipped with an anti-theft system, make sure you have the correct activation code before disconnecting the battery. 2)Detach the electrical connector and any ground straps from alternator. 3) Remove the fresh-air duct and the splash shield under the front of vehicle. 4) Unbolt the A/C compressor and set it aside, but don't disconnect the hoses. 5) Loosen the alternator adjusting bolt and tensioner bolt, then detach the drive belt. 6) Make sure the new(rebuilt) alternator looks identical to old one. Many new or rebuilt alternators don't have a pully installed, so you may have to use the pully from the old alternaor. 7) Installation is the reverse of removal.HAVE FUN ! -CEPS- THIS IS FOR THE 2.5 LITRE V-6 - CE
User Avatar

Wiki User

โˆ™ 2011-09-13 00:17:54
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you change the alternator on a 1994 probe SE?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will a sunroof from a 1995 Ford Probe GT fit into a 1994 Ford Probe SE?

Yessir, it will.


What is the proper spark plug gap for a 1994 ford probe se?

I want to know what is the proper spark plug gap for my car. It's a Ford Probe 1994, 4 cylinders and 2.0L


What is the probe size?

Probe,probe se 2.0 / probe gt 2.5


Where is the location of the starter solenoid on a 1994 Ford Probe SE?

It is connected to the starter.it is on the driver side of the engine at the back side.


Where is the crankshaft position sensor on a 96 Ford Probe SE?

"Where is the crankshaft position sensor on a 96 ford probe SE?"


How do you change the ignition switch on a 1994 Nissan Sentra?

how do you change the ignition key switch on a 1994 nissian sentra se


Y does everything you read about your 1994 probe gt say it has a 2.5l engineit has a 3.0is this not the original engine?

The 2.5l 6 cylinder engine is the original engine in a 1994 ford probe gt and in the se and base it is a 2.0l 4 cylinder engine


How much horse power does a 95 probe SE have right out of the shop?

Right out of the gate a 95 probe SE has 120 hp


Why would a 1994 ford probe se run on only 3 cylinders?

plug wiers or plugs. it could also be somthing with the distributor.


How do you change an alternator for a Dodge Grand Caravan 3.8 se?

Remove the tray that holds the wiper motor assembly. This will give you the room needed to remove the alternator.


Will the Ford Probe GT raise your car insurance?

No it won't. I had a 95 Ford Probe Se 2.0L and when the transmission went i upgraded to a 93 Probe Gt 2.5L V6 and my insurance didn't change at all. I love the car.


Where is the place for the starter in ford probe 1994 SE 4-cylinder and where do you hit it to make it work?

Lower rear end of the engine passenger side

People also asked