The front blower resistor on a 98 Dodge Caravan is replaced by removing the cover and disconnecting the wiring harness. The resistor can then be pulled and a new one put in its place.
Somewhere in the path of the air that the rear blower motor blows
Failed blower motor, resistor or switch.
Behind the glove box
It's behind the glove box door
Behind the glove box door.
It is behind the glove box door.
It is over the right front strut tower, accessible under the hood.
The resistor block or blower motor resistor is used to control the speed of the blower motor. That is how you get the lower speeds on your air conditioning or heater. The higher the resistance the lower the speed of the motor.
You lower the glove box lid by releasing the catches on the sides. You unplug the resistor and remove the two 8mm hex head screws.
The resister is right behind the glove box.
Under the hood, over top of the pass side strut tower.
Because it needs a new blower motor resistor.
Behind the glovebox and it secured with only 2 screws.
Usually if the resistor is bad the heater will only run on full blast.
It is over the passneger side strut tower, under the hood, in the firewall.
It is over the passenger side strut tower, accessible from under the hood.
It is under the hood on the passenger side, up over the strut tower in the firewall.
Your truck has both. the resistor is between the switch & blower.thje resistor controls the blower speed
There are similar, but not the same.
It is located on the passenger side firewall in the engine compartment, right next to the strut housing.
Perhaps resistor packs on blower motors is defective and need replacement
It is in the fire wall, over top of the right strut tower, accessible under the hood.
when a blower motor only works on high, it is usually due to faulty resistor board. Should be located in the duct near the blower. the purpose of this is so the air blown by the blower keeps the resistors cool.