This, I presume is the last year of the type which had the squarish design of lights and rectangular reflectors, before Ford changed to the round lights and reflectors? If this is the case, there's a big plastic wing nut holding the light cluster in place and it's not obvious! You have to reach inside to the back of the light cluster and feel for the wing nut. Unscrew it and the light cluster will come loose. Then get hold of the light cluster with both hands and pull forward firmly, to unplug the two plastic pegs on the outside. If it's the newer design with two screws on the edge covered by the hatchback, they are T25 Torx screws, not Phillips or Pozidrive! The bulb is the usual bayonet 5W/21W side/brake light bulb.
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
Disconnect the four plastic screws holding the plastic plate in the back of the trunk. This exposes the tail and brake lights.
on another 51 plate fiesta.
how do i change rear brake pads on 53 plate Picasso hdi
running or parking lights, or plate light, but that is singular.
You can't. The C5 third brake light is an LED unit. If the unit has went out the entire unit needs to be replaced. There are two bolts that hold the unit in that are accessed by removing the rear plate holder.
The 1999 Mercury Sable license plate light and the right side brake light are on the same fuse. If the fuse was bad neither brake light would work. The problem probably is burnt out lightbulbs.
No, the license plate light is wired in with the rear tail lights, not the brake lights.
show please how change plate light on an 2007 nissan sentra
I have a starting promblem on my ford fiesta 1.4 diesel zetec on 55 plate is it likely to be the glow/core plugs, if so how do I change them, where are they situated?
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
take of rear brake drum,,,,disconnect flexy brake pipe,,,slacken brake shoes...2 bolts hold cylinder to back plate,,,they usually seized..tho...easy job tho,,you will have to bleed the brakes,,if your not familiar with cars...leave this one to a garage,,,cos its your brakes