are you kidding? The correct answer to replace the brake light bulb on a 1996 Toyota Corolla: The bulb needed is type 1157. After openeing the trunk you need to remove the trunk liner on the side (rigth side for this example)where the brake light bulb is out. The plastic capture grommets hold the liner in place. Once the grommets are removed there is a nut (10mm) that is a bright brass-like color. This needs to be removed. Then on the outside of the trunk on the tail-light lens left side there are two nuts black in color (10mm) they need to be removed. Now the fun starts .... you needto slide the whole assembly back. You will note two black plastic posts on the rear quarter-panel, do not remove these ... these are used to hold the tail-light assembly in place since on the inside of the tail light assembly there are two rod-like protrusions that slide into these brackets. So.... remove the screws and wiggle the assembly back and it "should" slde back so that you can get at the bulb socket hat you twist to remove from the assembly. Now the bulb is visible and you reverse the order of steps to get it all back together .... a miserable design!
HOW TO FIX A PARKING LIGHT ON A 1996 TOYOTA COROLLA
Check the brake light switch located under the 1989 Toyota Corolla. If the switch is stuck the parking light will continue to stay on.
A malfunctioning brake light relay switch will cause your 1993 Toyota Corolla brake lights to stay on all the time. The brake light relay switch is located beneath the drivers side dashboard.
Defective or mis-adjusted brake light switch
Usually at the top of the brake pedal. Usually at the top of the brake pedal.
How you change fog lights bulbs on a 2004 Toyota Corolla
A brake light switch may be bad if a 1996 Toyota Corolla will not go into gear and the brake lights don't work. Another issue could be in the shift lock solenoid.
It's because you have a short current somewhere. You need to check the brake light wiring.
Check your brake fluid level.
my2003 toyota corolla the airbag light is on
Don’t know
Resetting the oil light on a Toyota Corolla Verso is very easy to do. You just need to take the battery cables off the battery for a few minutes and then put them back on. This will reset the oil change light.