Brake Pads and Rotors
Dodge Intrepid
Volvo S60

How do you change the brake pads on a 1995 Dodge Intrepid?

343536

Top Answer
User Avatar
Wiki User
2015-07-15 21:16:32
2015-07-15 21:16:32

There are two bolts holding the caliper in place. Remove the bolts, which face the center of the car and the caliper swings away on the flexible brake fluid hose. The pads snap out and are easily replaced. You can then either use large plyers to force the pistons back in or open the brake fluid valve and the piston will go in more easily but you need a way to bleed the air out of the system, if you open it and allow air in.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The fuel filter 1995 dodge Intrepid is on the passenger side. The filter is towards the back of the car.

User Avatar

what does rack and pinion steering consist of and do on a 1995 Dodge Intrepid?

User Avatar

The 1995 Dodge Intrepid has two motor mounts. One on the left and one on the right.

User Avatar

The trunk release in a 1995 Dodge Intrepid is under the dashboard on the driver's side. There is also a remote trunk release.

User Avatar

It could, it was an option.

User Avatar

The 1995 Dodge Intrepid does not have and ODB2 port, the Intrepids didn't introduce ODB2 until 1996.

User Avatar

The voltage regulator on a Dodge Intrepid is inside the engine computer.

User Avatar

the fuel filter is located passengers side in front of rear tire

User Avatar

it could havebeen built with it or with out

User Avatar

In the plastic bottle on the inner fender.

User Avatar

Disconect the battery for a few minutes!

User Avatar

As long as they are the same size and all the plumbing and eletrical line up. A 3.3 liter into a 3.3 liter, for example.

User Avatar

trying to replace the starter on a 1995 3.3 dodge intrepid! what problems if any can i anticipate?

User Avatar

The dodge intrepid didn't come out until 1995. the type of automatic transmission in it is the A606 also known as a 42LE transaxle.

User Avatar

There are three black caps that screw off in the trunk behind the brake light itself unscrew them and the assembly comes out then change bulb

User Avatar

Chrysler/Plymouth/Dodge vehicles do not use inertia/reset switches.

User Avatar

it means end of codes is all 55

User Avatar

5 quarts for the 3.3liter 6 quarts for the 3.5liter


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.