To change the cylinder head gasket on a Honda CR-V, first, disconnect the battery and drain the engine coolant. Remove the necessary components, including the intake and exhaust manifolds, and detach the cylinder head from the engine block. Clean the mating surfaces thoroughly, place the new gasket, and reassemble the cylinder head and components in the reverse order. Finally, refill the coolant, reconnect the battery, and start the engine to check for leaks.
What is the head torque specs on a 1997 Honda CRV
It IS possible that the new head gasket was not installed properly - either the gasket slipped or the head was not torqued down properly or in the proper sequence (don't feel bad it has happened MANY times to LOTS of other people) - OR - there is a crack in the block itself and the engine might have to be replaced.
Torque to 20ft/lbs initially. Then tighten to 65ft.lbs. Oil head bolts before installing.
How do you change the differential (rear) in 2005 Honda CRV
Most trans pans do not have oil drain plugs. Remove the pan, replace gasket.
How do I change my fuel filter on my 2002 Honda crv? Where is it located at? How do I change my fuel filter on my 2002 Honda crv? Where is it located at?
Youtube has a video showing how to replaced the rear pads for a 2003 crv (02 crv is the same as the 2003 crv). At youtube type in 2003 Honda crv brake change. The video is very good.
160000km
Which bulb?
any known problems with 2007 honda crv
Yes to both products. .
The firing order on the 1999 Honda CRV 2.0 is 1, 3, 4, 2. Cylinder 4 is closest to the passenger space and # 1 is closest to the front of the vehicle.