0
How do you change the distributor module on a 1987 Chevy Celebrity?
Wiki User
∙ 14y ago
If your 1987 Celebrity has the 4 cylinder 2.5L engine
The ignition module is mounted to the engine block beneath the intake manifold. First unplug the electrical connector, then mark the spark plug wires so you know where to put them back and unplug the spark plug wires. Remove the bolts that hold the ignition module in place. Then unplug the module from the crankshaft position sensor and remove the module from the vehicle. Reverse the procedure to reinstall.
If your vehicle has the V6 2.8L engine:
Raise the car and put on stands as necessary.
The ignition module is bolted to the block below the exhaust manifold on the radiator side of the engine. Unplug the electrical connections. Mark the spark plug wires so you know where to put them back and unplug them. Next remove the bolts that hold the module in place and remove it. Reverse the procedure to reinstall.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the ignition module on a 1986 Chevy Celebrity?
On the V6 the ignition module is under the distributor cap.
How do you change the ignition control module in a 1989 Chevy Celebrity?
Which engine does your car have?
How do you set the timing on 1987 2.5 celebrity?
The 1987 Chevy Celebrity has distributor less ignition. The timing is controlled by the engine control module and there is no provision for adjustment.
Where is the ingnition module on a 1987 Chevy Celebrity 2.8 liter that has no distributor cap?
I believe that one sits under the coil packs.
Where is the ignition control module on your 1990 Chevy k2500 pickup?
it's underneath the rotor in the distributor. you have to take the distributor out to change it.
How do you set the timming on an 87 Chevy Celebrity a 2.8 engine?
Timing on a 1987 thru 1990 Chevy Celebrity 2.8/3.1 engine is controlled by the ignition control module along with the engine control module. There is no provision or specification for manually adjusting the timing on these distributor-less models.
Can you change the distributerless on a 1989 Chevy Celebrity?
You can replace the ignition control module and the crankshaft position sensor as required.
Can I put the ECM module from my 1990 Chevy Celebrity wagon into an 86 Chevy Celebrity wagon?
Yes
Where is a ignition control module a 1987 Chevy blazer s10?
The ignition module is located in the distributor, under the distributor cap.
Where is the electronic spark control module on a1993 Chevy 1500?
The ESC module is in the distributor
Where do you locate and change the ecm on a 1996 Chevy lumina van apv?
I think the module is in the distributor with two phillips screws
Were is the ingition control module on your 1985 Chevy s-10 2.8?
The ign. control module on a 2.8L s10 is in the distributor. Remove the distributor cap and it is attached to the base of the distributor
