I changed the doors on my 89 caprice.To change the electric switch you have to pull most of the interior panel loose from the door to get at the back of the switch .there was a blue knob on the back of the switch and I had to twist/pull this off and then pull the plug off of the switch.hope this helps.
Maybe its your driver-side window regulator that stopped working.
Both window switch on the front door will lower the window, the problem is that both switch will not raise the window back up to its close position and also the master window switch on the Driver's side will not operate all the time nor will the master door lock on the driver's side lock the passenger side door. On several ocasion the driver's side window switch lowered it's window and it would'nt raise the window back up unless after quite a few minutes playing with the window switch, opening the door, etc.
It's held on by one screw in the hand hold.
From my 07 manual:Start the engine. Push down and hold the driver's window switch until the window is fully open.Pull and hold the driver's window switch to close the window completely, then hold the switch for about 2 seconds.
The most likely reason is that the child guard switch on the driver's side is in the "on" position.
Try swapping it with the driver's side switch
it should on the driver side door it should on the driver side door
I would try the window switch first , but if you are going to replace the switch then you will see how to replace the motor. You would have to take the door panel apart after that its easy.
2007 Saturn ion passenager window wont go down replaced motor door switch & driver side main switch
had same problem; check switch on driver side ., if it operates the passenger side ok, then just replace the driver side window switch .. $20 part from the dealer.
you have to replace the central switch cluster in whole. cant be repaired individually.
check to see if the window switch of the driver's side is getting power, if you are getting power to the switch and the switch is sending power out to the motor but the motor is not responding the motor needs to be replaced