answersLogoWhite

0


Best Answer

Maybe its your driver-side window regulator that stopped working.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why did the driver window switch stop working when the passenger switch on the drivers side is still working?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would the passenger window buttons not work on a 1999 ford explorer?

Check the drivers side switch panel for the switch that locks out the passenger windows from working, make sure it is not on.


How do you repair power window switches on drivers side Lincoln Continental 2002 can only open drivers side and right rear from drivers control left rear and passenger will not work from driver?

Replace driver's switch assembly


What is the problem if passenger windows can only be opened by the switch on drivers panel and drivers window does not work at all?

Sounds like a defective switch on the driver's door disconnected wires on either door or you have a lock out switch turned on... with driver door, i suggest pulling your "panel" off and verify your switch is actually connected and if it is, then replace the switch


Why would the driver window stop working on our 1991 GMC suburban?

Probably a bad switch in the drivers door.


Ford explorer door lock switch wont lock passenger side door?

Lock on driver frot side is not working


Why does the drivers side window work but not the passenger side?

2007 Saturn ion passenager window wont go down replaced motor door switch & driver side main switch


Why does the window on a 1998 Ford Taurus driver side stopped working?

Often the plug in connector at the drivers side switch can becaome loose and break the connection. Remove the switch and check this.


Driver side power window is ok but the passenger side is not working on 1989 aerostar motor and regulator is fine what else could be wrong?

Hi, The problem with your pass side window is the drivers side power window switch. I have had this same problem on my 1993 Aerostar.


Why is your driver side window switch for passenger window and passenger window switch not working on my 97 mercury sable all other windows are working fine?

Check to see if you are getting power to the motor if so window motor is defective Could be open wire usually in the door jamb area


How do you change drivers on a 2003 Chevrolet avalanche?

Not sure which avalanche you have but I have the 03 Northface all you have to do to switch drivers is switch that remote you open the doors with.. On my friend's there was a driver one and driver two option on a button on the drivers door.


On a 1998 Nissan Sunny the front passenger window goes down but not up using the switches on the passenger's and driver's sides what is wrong?

On Nissans, the passenger and both rear door window switches get their power through the master (drivers door) switch. First thing to try is playing with the master switch. Move the master switch button that is inop to the position that is not working and move it around with your finger. If this don't work, remove the master switch and clean the contacts, maybe with some silicon spray and then test if you have power leaving the switch. If not, the switch probably needs to be replaced. Have seen this happen on other cars and it has been the passenger door switch. It is most probably a double pole double throw switch and both sides of the switch need to work to make the window go both ways. Check the connections on the back of the switch and/or interchange it with one from another door. I think most likely a wiring fault at the passenger door switch and the drivers door switch have the same fault. Ken


Where is the driver side door module located on a 2003 suburban?

The Drivers Door Module or Passenger Door Module on a 2003 suburban is also known as the "window / door lock" switch. These modules are located on each respective door, i.e. driver side door or passenger side door. It is the module that has the door lock/unlock switch and window up/down switch. Hope this helps...