answersLogoWhite
Chevy Impala
Turn Signals and Hazard Lights
DIY Projects

How do you change the emergency flasher module in a 2001 Chevrolet Impala?

676869

Top Answer
User Avatar
Wiki User
2015-07-15 21:20:36
2015-07-15 21:20:36

You need to pull the whole front dash pannel off. There are also about 6 screws holding it on each end, (left and right), and below. I found I needed to take my ignition key off the ring put it in the ignition and position to run so that I could put the column shift into 1 (full down) and put the steering wheel to full down in order to get the clearance to get the pannel off. It seems like quite a nusance, and nerve wracking to be pulling the whole pannel off at once, but it worked.

The emergency flasher also controls the regular turn signals. Mine stopped working a few weeks ago. I took it out. Tapped it with the handel of a screw driver and it started working again.

I tried to "sign-in" but was not successful. My e-mail is tfritz@digiflight.com

Tom F

1

Related Questions

User Avatar

The emergency signal flasher module can be found below the dashboard, on the drivers side of the engine compartment. The emergency signal flasher module simply plugs in and out.

User Avatar

A 2003 Impala does not have a timing belt. It has a chain.

User Avatar

It is part of the hazard warning module and part of the switch

User Avatar

how do you replace a transmission pressure control solenoid in a 2003 chevrolet impala

User Avatar

http://wiki.answers.com/Q/Replacing_a_rear_light_bulb_on_a_1999_monte_carlo_where_do_you_go_to_access_the_rear_right_light

User Avatar

Yes. You'll need to change the exhaust and cooling systems.

User Avatar

As per the intructions on page 6-39 of your "Owner's Manual"...

User Avatar

You will have to remove the gas tank and install a fuel module.

User Avatar

For best performance it would be best to do so every 30,000 miles.

User Avatar

The turn signals and emergency flashers are both controlled electronically. The module is behind the emergency flasher switch and requires partial disassemble of the dash to access it There are several screws: 2 on the ends under the fuse covers 2 on the panel under the steering wheel and 2 by the odometer Gently pull the face off the dash. Don't break off the clips. A replacement is about $40 from the dealer.

User Avatar

It is mounted on a bracket under the dash at the brake pedal. From there it is self explanatory.

User Avatar

Provided you have a lift and a transmission jack the time will be about 5 1/2 hours.

User Avatar

You will have to drop the fuel tank to access the fuel module. It is not a job to do on the ground.

User Avatar

The fuel filter is located on the driver's side of the frame and will require a special tool to replace it.

User Avatar

It's right up in front on the dash. It's part of the hazard switch.

User Avatar

A pdf file with pictures is available at the web site below: http://www.allergybegone.com/buick-century-chevrolet-impala-cabin-air-filter.html

User Avatar

take the pins of the front right light and look down and it will be there. size of the bolt is 10" mm PS. i put a horn of a Cadillac on my is sound good ( impala ls 05)

User Avatar

I found this answer: http://www.justanswer.com/uploads/advautoca/2008-10-01_185451_multifunction_switch_replace_with_linked_documents.pdf

User Avatar

How do you change the flasher on a Chevy S-10?

User Avatar

There is one screw that holds the fog light it into place.Unscrew that screw and the fog light will pull out of the bumper.

User Avatar

How do you change a tag light on a 2002 impala


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.