On the 93 the two top screws are are visable and easy to remove. To get at the two botom onea you have to remove/loosen some of the plastic grill. Then just unplug and reinstall.New but related questionHow do I get the grill off? I can get the top clips off, but I can not figure out the bottom ones. This is on a 90 actually.
89 toyota pickup v6 engine anti knock sensor location
It probably needs a new clutch.
I own a 92' Toyota pickup and i recently changed the fuel filter. It sat down between the block and the intake manifold on the back near the firewall. Check there.
harmonic balance has left hand thread
It is a 30 Amp fusible link in fusebox under the hood.
fule filter needs replacing
passenger side up under the bed right in front of the back rear tire.
you need to remove the transmission then unbolt the clutch from the flywheel.
Yes as long as the truck is not a T100. The 92 and 93 model years were the same as far as the doors are concerned. The only difference you will see is between the 2wd and the 4wd. They had different marker lights in the front.
no it is not a simple matter.
What should the timing be on a 92 Toyota 3.0
the 92 4afe toyota engine does not have a crankshaft position sensor
You will need to change it out. The bearing is failing.
External or internal leak. If there is no apparent external leak and you see white smoke then you have a blown head gasket.
Where is heater core located on 92 chev
look in your owners manual, its in there
undo the two 3/32 bolts running thru headlamp assemblies and remove headlamp assembly to access bulb
Because your in 4 wheel drive mode? Switch and or linkage out of adjustment. Bad switch. Bad Relay. Grounded circuit.
With a Toyota leaf spring removal tool. Just go to your local Toyota dealer, head into the parts dept, and tell 'em you need a leaf spring removal tool for a 92 pick up. If their any kind of dealer, they will have it in stock.
If you can't see it easily(i own one), then you arent qualified to replace it. Very easily spotted if you know what one is. If you can't identify it, you can change it. Find a professional.It on right front below PS pump pulley back a few inches.
That is how it was designed and built.