You pop the hood, reach behind the headlight and twist the plastic piece holding the bulb(its attached to a wire) and it comes right off. if you cant reach you might have to remove afew screws. real simple.
How do you change the headlight globe on a Ford BA?
the glass cover on the headlight is not servicable, they are glued during assembly. you have to replace the entire headlight globe or headlight assembly.
not sure
Ok I will answer this myself as I figured it out( so much for the internet hey). You have to take off the bumper so you can get to all the screws on the headlight, take out the headlight and from then on it's pretty straight forward.
undo 3 Phillips head screws spread along bottom of black headlight casing(1 under indicator,1 under park light,1 under head light) then lift out whole unit....apply a little pressure to get it out as its held in by clips too....then half turn at back of casing where wires run in and headlight should just come out...change globe and reverse process.....take about 10 mins...
Undo the hex nut on top of the headlight assembly and remove bolt. Grap bottom front of headlight assemby and pull hard upwards causing the bottom pins to release then pull directly outwards to release the top pins. Turn back of globe anti clockwise to release globe from headlight assembly.
Well on mine a 95 limited open the hood look above the headlight and there is a cover that can be lifted. then look down and you will see the rear of the headlight. now are you tring to replace the blub or the entire globe? to change just thew blub it;s easy just locate the connector to the headlight and twist it counter clock wise and the connector and blub should come out than just repllace the blub and put it back. now if you have to change the globe it is a pain in the neck, you have to remove the front grill., good luck.,.
look on the top of the light right where the hood close it should be two wings they turn left and right the hold light globe will come out so be carefull,then the build fits in the globe
Not sure what you mean by "Globe" however... Mazda 3 headlight bulb lamp replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
A variable is something that can change in a experiment. A globe can't really change, so no. -yoda
earth
When you lift the bonnet you will notice two circular srew on cover plates attached to the headlight. The inside one houses the park lights and the outside cover houses the haedlight. Unscrew the cover and then unclip the bracket holding the globe. When installing the new globe take care not to touch the glass and contaminate it.