Ok I will answer this myself as I figured it out( so much for the internet hey). You have to take off the bumper so you can get to all the screws on the headlight, take out the headlight and from then on it's pretty straight forward.
From under the hood behind the headlight you can see where the bulb snaps in un snap it pull it out and there's your bulb, get the number off of it and replace , cost about $10 , I did this about two months ago...
globe
Is the globe is not the most accurate of all maps.
There is a range of snow globe sizes and designs, but the most common is a 4" diameter glass globe, seated on a base that is no larger than 4.5" x 4.5". when placed together, the globe plus base is 7-8" tall.
Draw the globe stand, then place the globe in it. Then draw the landmarks and do some shading to make the globe look 3Dimensional.
How do you change the headlight globe on a Ford BA?
not sure
Undo the hex nut on top of the headlight assembly and remove bolt. Grap bottom front of headlight assemby and pull hard upwards causing the bottom pins to release then pull directly outwards to release the top pins. Turn back of globe anti clockwise to release globe from headlight assembly.
Well on mine a 95 limited open the hood look above the headlight and there is a cover that can be lifted. then look down and you will see the rear of the headlight. now are you tring to replace the blub or the entire globe? to change just thew blub it;s easy just locate the connector to the headlight and twist it counter clock wise and the connector and blub should come out than just repllace the blub and put it back. now if you have to change the globe it is a pain in the neck, you have to remove the front grill., good luck.,.
It is a slow car
You pop the hood, reach behind the headlight and twist the plastic piece holding the bulb(its attached to a wire) and it comes right off. if you cant reach you might have to remove afew screws. real simple.
the glass cover on the headlight is not servicable, they are glued during assembly. you have to replace the entire headlight globe or headlight assembly.
look on the top of the light right where the hood close it should be two wings they turn left and right the hold light globe will come out so be carefull,then the build fits in the globe
Not sure what you mean by "Globe" however... Mazda 3 headlight bulb lamp replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
A variable is something that can change in a experiment. A globe can't really change, so no. -yoda
earth
When you lift the bonnet you will notice two circular srew on cover plates attached to the headlight. The inside one houses the park lights and the outside cover houses the haedlight. Unscrew the cover and then unclip the bracket holding the globe. When installing the new globe take care not to touch the glass and contaminate it.