Its a bit tricky but removal of the underpanaling and glove box are required. Also there will be a tricky cover that covers the blower motor, do not be afraid to be a little stern when removing it. Its not bolted anywhere but merelly snugs around the assymbly. Altho you will need to unplug the power wires going to it before removing it. Also there is a set of relays on some models bolted on a bracket nearby, , removing the bracket will aid in removing the blower motor. Always be careful in this area for the ECU sits above in this location. There will be 5 , 7mm bolts aurrounding the blower motor. after removing them it gets a little tricky again, when you pull out the blower motor the blower motor fan will keep you from just pulling it out. You will have to manuever it downward angle to get the fan to clear the opening. The fan is plastic and very durable. Put things back together in the exact order. If not something will come out wrong, trust meeh ive done many of these.your power wires MUST be plugged after the heat coat /cover is put on.
The heater blower for a 2002 Chevy Silverado is mounted under the dash. It is on the passenger side, in the heater housing.
If yourtalking about the heater blower, I believe they are hidden behind the glove box inner liner.
Bad blower resistor?
The Heater Core will be located behind the dash. Hope that Helps.
On my 1993 K1500 Silverado, it is behind the heater/ac blower assy. However, I can not find any info on how to get the assy apart, or where it is connected to the dash switch.
you have waisted my time, thank you
You may want to check the heater blower resistor, its behind the glove compartment
In a 1997 Jeep Wrangler, the relay switch for the heater blower and motor is located behind the dash. It will be directly behind the HVAC knobs behind the dashboard.
The blower resistor is located behind the dashboard. It is found behind the heater near the center of the vehicle.
the blower motor is behind the glove box under the dash
how do i change my blower motor on my 2007 malibu
remove the right side of the dash, remove ductwork. its behind the glove box